Cisco 350-401認証Pdf資料試験に合格することは簡単ではなくて、適切な訓练を選ぶのはあなたの成功の第一歩です。情報源はあなたの成功の保障で、NewValidDumpsの商品はとてもいい情報保障ですよ。君はNewValidDumpsの商品を選ばればCisco 350-401認証Pdf資料認証試験に合格するのを１００％保証するだけでなくあなたのために1年の更新を無料で提供します。 NewValidDumpsにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 350-401認証Pdf資料認証試験に参加する方に対して問題集を研究続けています。君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにNewValidDumpsを選択してください。 NewValidDumpsはあなたが100% で350-401認証Pdf資料試験に合格させるの保証することができてまたあなたのために一年の無料の試験の練習問題と解答の更新サービス提供して、もし試験に失敗したら、弊社はすぐ全額で返金を保証いたします。

CCNP Enterprise 350-401 」とゴーリキーは述べました。

我々NewValidDumpsは一番効果的な方法を探してあなたにCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)認証Pdf資料試験に合格させます。 しかも１００パーセントの合格率を保証できます。NewValidDumpsのCiscoの350-401 試験参考書試験トレーニング資料を手に入れたら、あなたは自分の第一歩を進めることができます。

NewValidDumpsは多くの受験生を助けて彼らにCiscoの350-401認証Pdf資料試験に合格させることができるのは我々専門的なチームがCiscoの350-401認証Pdf資料試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの350-401認証Pdf資料試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。

Cisco 350-401認証Pdf資料 - きっと君に失望させないと信じています。

このインターネット時代において、社会の発展とともに、コストがより低くて内容が完全な情報が不可欠です。弊社の350-401認証Pdf資料問題集は他のサイトに比べて、試験の範囲をカバーすることはより広くて、合理的な価格があります。しかしも、品質はもっと高くて一度350-401認証Pdf資料試験に合格したい客様に対して、我が社の350-401認証Pdf資料はあなたの最高選択かつ成功のショートカットであると思われます。

我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。NewValidDumps Ciscoの350-401認証Pdf資料試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。

350-401 PDF DEMO:

QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確のUSGBC LEED-Green-Associate試験問題集を開発するのに準備します。 SAP C_TS4CO_2023-JPN - ためらわずに速くあなたのショッピングカートに入れてください。 あなたは弊社の商品を使用した後、一回でCisco　Microsoft DP-700試験に合格できなかったら、弊社は全額返金することを承諾します。 NewValidDumpsのCiscoのISACA CCAK試験トレーニング資料はインターネットでの全てのトレーニング資料のリーダーです。 我々社はCisco　IIA IIA-CIA-Part2試験に準備するあなたに怖さを取り除き、正確の方法と問題集を提供できます。

Updated: May 28, 2022