350-401ファンデーション 資格取得

NewValidDumpsを選んだら、あなたは簡単に認定試験に合格することができますし、あなたはITエリートたちの一人になることもできます。まだ何を待っていますか。早速買いに行きましょう。 Cisco 350-401ファンデーション資格認定はバッジのような存在で、あなたの所有する専業技術と能力を上司に直ちに知られさせます。次のジョブプロモーション、プロジェクタとチャンスを申し込むとき、Cisco 350-401ファンデーション資格認定はライバルに先立つのを助け、あなたの大業を成し遂げられます。 NewValidDumpsのCiscoの350-401ファンデーション試験トレーニング資料はCiscoの350-401ファンデーション認定試験を準備するのリーダーです。

先月、350-401ファンデーション試験に参加しました。

Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)ファンデーションの購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)ファンデーション試験に一番信頼できるヘルプを提供します。 あなたはその他のCisco 350-401 復習時間「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に関するツールサイトでも見るかも知れませんが、弊社はIT業界の中で重要な地位があって、NewValidDumpsの問題集は君に100%で合格させることと君のキャリアに変らせることだけでなく一年間中で無料でサービスを提供することもできます。

自分の能力を証明するために、350-401ファンデーション試験に合格するのは不可欠なことです。弊社の350-401ファンデーション真題を入手して、試験に合格する可能性が大きくなります。社会と経済の発展につれて、多くの人はIT技術を勉強します。

Cisco 350-401ファンデーション - 試験の準備は時間とエネルギーがかかります。

NewValidDumpsはIT試験問題集を提供するウエブダイトで、ここによく分かります。最もよくて最新で資料を提供いたします。こうして、君は安心で試験の準備を行ってください。弊社の資料を使って、100%に合格を保証いたします。もし合格しないと、われは全額で返金いたします。NewValidDumpsはずっと君のために最も正確なCiscoの350-401ファンデーション「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験に関する資料を提供して、君が安心に選択することができます。君はオンラインで無料な練習問題をダウンロードできて、100%で試験に合格しましょう。

Ciscoの350-401ファンデーションの試験の資料やほかのトレーニング資料を提供しているサイトがたくさんありますが、Ciscoの350-401ファンデーションの認証試験の高品質の資料を提供しているユニークなサイトはNewValidDumpsです。NewValidDumpsのガイダンスとヘルプを通して、初めにCiscoの350-401ファンデーション「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の認証を受けるあなたは、気楽に試験に合格すことができます。

350-401 PDF DEMO:

QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

Cisco Fortinet FCP_FGT_AD-7.4-JPN「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格することが簡単ではなくて、Cisco Fortinet FCP_FGT_AD-7.4-JPN証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。 Amazon SAA-C03 - 試験に受かったら、あなたはIT業界のエリートになることができます。 Huawei H12-111_V3.0 - 今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。 Amazon SAA-C03-KR - これは試験に合格した受験生の一人が言ったのです。 NewValidDumpsは実際の環境で本格的なCiscoのGoogle Google-Workspace-Administrator-JPN「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の試験の準備過程を提供しています。

Updated: May 28, 2022

350-401ファンデーション - Cisco Implementing Cisco Enterprise Network Core Technologies 350-401 Encor最速合格

PDF問題と解答

試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282
Cisco 350-401 基礎訓練

  ダウンロード


 

模擬試験

試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282
Cisco 350-401 資格専門知識

  ダウンロード


 

オンライン版

試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282
Cisco 350-401 参考書内容

  ダウンロード


 

350-401 学習資料