我々NewValidDumpsはCiscoの350-401復習対策書試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の350-401復習対策書試験問題集を開発するのに準備します。 NewValidDumpsを利用したら、あなたはきっと高い点数を取ることができ、あなたの理想なところへと進むことができます。IT認証資料を提供したほかのサイトより、NewValidDumpsのプロかつ高品質の製品は最高のものです。 ほんとんどお客様は我々NewValidDumpsのCisco 350-401復習対策書問題集を使用してから試験にうまく合格しましたのは弊社の試験資料の有効性と信頼性を説明できます。
350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)復習対策書問題集を利用して試験に合格できます。 そうすると、350-401 試験解答問題集の品質を知らないままに問題集を購入してから後悔になることを避けることができます。350-401 試験解答問題集の品質を確かめ、この問題集はあなたに合うかどうかを確認することができるように、NewValidDumpsは350-401 試験解答問題集の一部のダウンロードを無料で提供します。
NewValidDumpsにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が100%にまで達します。弊社のみたいなウエブサイトが多くても、彼たちは君の学習についてガイドやオンラインサービスを提供するかもしれないが、弊社はそちらにより勝ちます。NewValidDumpsは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。
Ciscoの350-401復習対策書試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でNewValidDumpsは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。
もし学習教材は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。NewValidDumpsのCiscoの350-401復習対策書試験トレーニング資料は正確性が高くて、カバー率も広い。
QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D
QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.
QUESTION NO: 3
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.
QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.
QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.
ITの専門者はCiscoのMicrosoft PL-300-KR認定試験があなたの願望を助けって実現できるのがよく分かります。 NewValidDumpsのCiscoのSAP C_THR86_2405試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。 NewValidDumpsの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoのISQI CAE認定試験対策模擬テスト問題集が研究しました。 Tableau SCA-C01-JPN - なぜ弊社は試験に失敗したら全額で返金することを承諾していますか。 H3C GB0-392 - あなたはいつでもサブスクリプションの期間を延長することができますから、より多くの時間を取って充分に試験を準備できます。
Updated: May 28, 2022
試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282 問
Cisco 350-401 学習関連題
ダウンロード
試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282 問
Cisco 350-401 キャリアパス
ダウンロード
試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282 問
Cisco 350-401 PDF問題サンプル
ダウンロード