Ciscoの350-401問題無料認定試験は実は技術専門家を認証する試験です。Ciscoの350-401問題無料認定試験はIT人員が優れたキャリアを持つことを助けられます。優れたキャリアを持ったら、社会と国のために色々な利益を作ることができて、国の経済が継続的に発展していることを進められるようになります。 NewValidDumpsの仮想ネットワークトレーニングと授業は大量の問題集に含まれていますから、ぜひあなたが気楽に試験に合格することを約束します。親愛なる受験生の皆様、何かCiscoの350-401問題無料試験のトレーニング授業に加入したいのですか。 」とゴーリキーは述べました。

CCNP Enterprise 350-401 もちろんありますよ。

CCNP Enterprise 350-401問題無料 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) その資料は最完全かつ最新で、合格率が非常に高いということで人々に知られています。 君がCiscoの350-401 試験過去問問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの350-401 試験過去問問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。

この問題集はあなたが少ない労力で最高の結果を取得することができます。NewValidDumpsはIT認定試験を受験した多くの人々を助けました。また、受験生からいろいろな良い評価を得ています。

解決法はCisco 350-401問題無料問題集は購入することです。

近年、IT領域で競争がますます激しくなります。IT認証は同業種の欠くことができないものになりました。あなたはキャリアで良い昇進のチャンスを持ちたいのなら、NewValidDumpsのCiscoの350-401問題無料「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料を利用してCiscoの認証の証明書を取ることは良い方法です。現在、Ciscoの350-401問題無料認定試験に受かりたいIT専門人員がたくさんいます。NewValidDumpsの試験トレーニング資料はCiscoの350-401問題無料認定試験の１００パーセントの合格率を保証します。

そのデモは350-401問題無料試験資料の一部を含めています。私たちは本当にお客様の貴重な意見を350-401問題無料試験資料の作りの考慮に入れます。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

Microsoft AZ-305-KR - NewValidDumpsに会ったら、最高のトレーニング資料を見つけました。 NewValidDumpsはCiscoのFortinet FCP_FAZ_AD-7.4の認定試験の受験生にとっても適合するサイトで、受験生に試験に関する情報を提供するだけでなく、試験の問題と解答をはっきり解説いたします。 EMC D-VXR-OE-01 - これは試験の準備をするために非常に効率的なツールですから。 資料を提供するだけでなく、CiscoのEMC DES-3612試験も一年の無料アップデートになっています。 Huawei H12-831_V1.0-ENU - そうだったら、下記のものを読んでください。

Updated: May 28, 2022