IT認定試験の中でどんな試験を受けても、NewValidDumpsの350-401関連日本語内容試験参考資料はあなたに大きなヘルプを与えることができます。それは NewValidDumpsの350-401関連日本語内容問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。真剣にNewValidDumpsのCisco 350-401関連日本語内容問題集を勉強する限り、受験したい試験に楽に合格することができるということです。 誠意をみなぎるCisco　350-401関連日本語内容試験備考資料は我々チームの専業化を展示されるし、最完全の質問と再詳細の解説でもって試験に合格するのを助けるます。同時的に、皆様の認可は我々仕事の一番良い評価です。 その中で、350-401関連日本語内容認定試験は最も重要な一つです。

CCNP Enterprise 350-401 どんな質問があっても、すぐ返事できます。

なぜなら、それはCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)関連日本語内容認定試験に関する必要なものを含まれるからです。 だから、あなたはコンピューターでCiscoのウエブサイトを訪問してください。そうすれば、あなたは簡単に350-401 日本語Pdf問題復習教材のデモを無料でダウンロードできます。

それは正確性が高くて、カバー率も広いです。あなたはNewValidDumpsの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。NewValidDumpsのCiscoの350-401関連日本語内容試験トレーニング資料はCiscoの350-401関連日本語内容認定試験を準備するのリーダーです。

Cisco 350-401関連日本語内容 - 最もよくて最新で資料を提供いたします。

あなたはIT職員ですか。成功したいのですか。成功したいのならNewValidDumpsのCiscoの350-401関連日本語内容試験トレーニング資料を利用してください。当社の資料は実践の検証に合格したもので、あなたが首尾よくIT認証試験に合格することを助けます。NewValidDumpsのCiscoの350-401関連日本語内容トレーニング資料を手に入れたらあなたはIT業種でもっとよい昇進を持つようになり、高レベルのホワイトカラーのトリートメントを楽しむこともできます。あなたはまだ何を心配しているのですか。NewValidDumpsのCiscoの350-401関連日本語内容トレーニング資料はあなたのニーズを満たすことができますから、躊躇わずにNewValidDumpsを選んでください。NewValidDumpsはあなたと苦楽を共にして、一緒に挑戦に直面します。

Cisco 350-401関連日本語内容「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格することが簡単ではなくて、Cisco 350-401関連日本語内容証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。

350-401 PDF DEMO:

QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

Salesforce Salesforce-AI-Specialist - 誰もが成功する可能性があって、大切なのは選択することです。 Huawei H19-260_V2.0 - 今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。 HP HPE2-T37 - あなたはIT職員としたら、NewValidDumpsはあなたが選ばなくてはならないトレーニング資料です。 Salesforce CRT-450-JPN - 試験問題と解答に関する質問があるなら、当社は直後に解決方法を差し上げます。 Microsoft AZ-900-JPN - NewValidDumpsはあなたを助けることができますから、心配する必要がないですよ。

Updated: May 28, 2022