試験に合格してからあなたがよりよい仕事と給料がもらえるかもしれません。Ciscoの350-401テスト内容試験は国際的に認可られます。これがあったら、よい高い職位の通行証を持っているようです。 弊社の350-401テスト内容のトレーニング資料を買ったら、一年間の無料更新サービスを差し上げます。もっと長い時間をもらって試験を準備したいのなら、あなたがいつでもサブスクリプションの期間を伸びることができます。 弊社のCiscoの350-401テスト内容練習問題の通過率は他のサイトに比較して高いです。

CCNP Enterprise 350-401 NewValidDumpsには専門的なエリート団体があります。

CCNP Enterprise 350-401テスト内容 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 商品の税金について、この問題を心配できません。 NewValidDumpsのCiscoの350-401 最新な問題集試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。それはあなたがいつでも最新の試験資料を持てるということです。

この問題に心配する必要がありませんし、我々社の無料に提供するCisco　350-401テスト内容PDF版を直接にダウンロードし、事前に体験できます。何か問題があると、ライブチャットとメールで問い合わせます。我々SiteName}を選択するとき、Cisco　350-401テスト内容試験にうまく合格できるチャンスを捉えるといえます。

Cisco 350-401テスト内容 - NewValidDumpsを選んだら、成功への扉を開きます。

数年以来の整理と分析によって開発された350-401テスト内容問題集は権威的で全面的です。350-401テスト内容問題集を利用して試験に合格できます。この問題集の合格率は高いので、多くのお客様から350-401テスト内容問題集への好評をもらいました。350-401テスト内容問題集のカーバー率が高いので、勉強した問題は試験に出ることが多いです。だから、弊社の提供する350-401テスト内容問題集を暗記すれば、きっと試験に合格できます。

IT技術の急速な発展につれて、IT認証試験の問題は常に変更されています。したがって、NewValidDumpsの350-401テスト内容問題集も絶えずに更新されています。

350-401 PDF DEMO:

QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

それは受験者の中で、GIAC GPCS試験参考書が人気がある原因です。 あるいは、無料で試験ServiceNow CIS-VR問題集を更新してあげるのを選択することもできます。 Esri EAPP_2025 - NewValidDumpsはもっぱら認定試験に参加するIT業界の専門の人士になりたい方のために模擬試験の練習問題と解答を提供した評判の高いサイトでございます。 VMware 2V0-41.24 - なぜ受験生のほとんどはNewValidDumpsを選んだのですか。 Microsoft AZ-500 - でも、この試験はそれほど簡単ではありません。

Updated: May 28, 2022