あなたより優れる人は存在している理由は彼らはあなたの遊び時間を効率的に使用できることです。どのようにすばらしい人になれますか？ここで、あなたに我々のCisco　350-401合格記試験問題集をお勧めください。弊社NewValidDumpsの350-401合格記試験問題集を介して、速く試験に合格して350-401合格記試験資格認定書を受け入れる一方で、他の人が知らない知識を勉強して優れる人になることに近くなります。 一回だけでCiscoの350-401合格記試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。NewValidDumpsは君にとってベストな選択になります。 あなたのご遠慮なく購買するために、弊社は提供する無料のCisco　350-401合格記問題集デーモをダウンロードします。

CCNP Enterprise 350-401 暇の時間を利用して勉強します。

我々の目的はあなたにCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)合格記試験に合格することだけです。 現在の社会で、350-401 日本語参考試験に参加する人がますます多くなる傾向があります。市場の巨大な練習材料から350-401 日本語参考の学習教材を手に入れようとする人も増えています。

自分のIT業界での発展を希望したら、Ciscoの350-401合格記試験に合格する必要があります。Ciscoの350-401合格記試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはCiscoの350-401合格記試験に合格することができます。Ciscoの350-401合格記試験を準備しているあなたに試験に合格させるために、我々NewValidDumpsは模擬試験ソフトを更新し続けています。

Cisco 350-401合格記 - 弊社の商品が好きなのは弊社のたのしいです。

NewValidDumpsを選択したら、成功が遠くではありません。NewValidDumpsが提供するCiscoの350-401合格記認証試験問題集が君の試験に合格させます。テストの時に有効なツルが必要でございます。

NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

SAP C_THR83_2405 - あなたに予想外の良い効果を見せられますから。 あなたはインターネットでCiscoのMicrosoft PL-300認証試験の練習問題と解答の試用版を無料でダウンロードしてください。 それはあなたがいつでも最新のAAPC CPC試験トレーニング資料をもらえるということです。 CompTIA PT0-002 - NewValidDumpsはまた一年間に無料なサービスを更新いたします。 そうしたらNewValidDumpsのCiscoのPalo Alto Networks SSE-Engineer試験に合格することができるようになります。

Updated: May 28, 2022