350-401最速合格 資格取得

その中で、350-401最速合格認定試験が最も重要な一つです。この試験の認定資格はあなたが高い技能を身につけていることも証明できます。しかし、試験の大切さと同じ、この試験も非常に難しいです。 そうすれば、あなたは簡単に350-401最速合格復習教材のデモを無料でダウンロードできます。そして、あなたは350-401最速合格復習教材の三種類のデモをダウンロードできます。 ですから、NewValidDumpsの350-401最速合格問題集を選択してください。

CCNP Enterprise 350-401 PDF、オンライン問題集または模擬試験ソフトですか。

NewValidDumpsのCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)最速合格試験問題資料は質が良くて値段が安い製品です。 我々NewValidDumpsはお客様の立場でお客様に最高のサービスを提供します。全日でのオンライン係員、Ciscoの350-401 認証資格試験資料のデモ、豊富なバーション、Ciscoの350-401 認証資格試験資料を購入した後の無料更新、試験に失敗した後の全額の返金…これら全部は我々NewValidDumpsが信頼される理由です。

NewValidDumpsのCiscoの350-401最速合格試験トレーニング資料はIT人員の皆さんがそんな目標を達成できるようにヘルプを提供して差し上げます。NewValidDumpsのCiscoの350-401最速合格試験トレーニング資料は100パーセントの合格率を保証しますから、ためらわずに決断してNewValidDumpsを選びましょう。Ciscoの350-401最速合格認定試験は実は技術専門家を認証する試験です。

Cisco 350-401最速合格 - 夢を持ったら実現するために頑張ってください。

努力する人生と努力しない人生は全然違いますなので、あなたはのんびりした生活だけを楽しみしていき、更なる進歩を求めるのではないか?スマートを一方に置いて、我々Ciscoの350-401最速合格試験問題集をピックアップします。弊社の350-401最速合格試験問題集によって、あなたの心と精神の満足度を向上させながら、勉強した後350-401最速合格試験資格認定書を受け取って努力する人生はすばらしいことであると認識られます。

あなたの夢は何ですか。あなたのキャリアでいくつかの輝かしい業績を行うことを望まないのですか。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

もしあなたはH3C GB0-382試験に合格しなかったら、全額返金のことを承諾します。 NewValidDumpsのSAP C_SAC_2421教材を購入したら、あなたは一年間の無料アップデートサービスを取得しました。 我々NewValidDumpsへのCisco Microsoft DP-600試験問題集は専業化のチームが長時間で過去のデータから分析研究された成果で、あなたを試験に迅速的に合格できるのを助けます。 SAP C_TFG51_2405 - ところで、受験生の皆さんを簡単にIT認定試験に合格させられる方法がないですか。 弊社はCisco Oracle 1z0-1109-24認定試験の最新要求に従って関心を持って、全面的かつ高品質な模擬試験問題集を提供します。

Updated: May 28, 2022

350-401最速合格、350-401受験方法 - Cisco 350-401テキスト

PDF問題と解答

試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282
Cisco 350-401 試験概要

  ダウンロード


 

模擬試験

試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282
Cisco 350-401 資格取得講座

  ダウンロード


 

オンライン版

試験コード:350-401
試験名称:Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)
最近更新時間:2024-12-22
問題と解答:全 1282
Cisco 350-401 専門トレーリング

  ダウンロード


 

350-401 過去問