350-401認証資格認定試験は専門知識と情報技術を検査する試験で、NewValidDumpsが一日早くCiscoの350-401認証資格認定試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」に合格させるのサイトで試験の前に弊社が提供する訓練練習問題をテストして、短い時間であなたの収穫が大きいです。 このような素晴らしい資料をぜひ見逃さないでください。IT技術の急速な発展につれて、IT認証試験の問題は常に変更されています。 試験に合格するのは簡単ではないもよくわかりましょう。

CCNP Enterprise 350-401 正しい方法は大切です。

CCNP Enterprise 350-401認証資格 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) そうしたら、あなたは自信を得ることができて、実際の試験で経験を活かして気楽に合格します。 試験が更新されているうちに、我々はCiscoの350-401 学習体験談試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。

短い時間に最も小さな努力で一番効果的にCiscoの350-401認証資格試験の準備をしたいのなら、NewValidDumpsのCiscoの350-401認証資格試験トレーニング資料を利用することができます。NewValidDumpsのトレーニング資料は実践の検証に合格すたもので、多くの受験生に証明された１００パーセントの成功率を持っている資料です。NewValidDumpsを利用したら、あなたは自分の目標を達成することができ、最良の結果を得ます。

Cisco 350-401認証資格 - 自分の幸せは自分で作るものだと思われます。

NewValidDumpsのIT専門家たちは彼らの豊富な知識と経験を活かして最新の短期で成果を取るトレーニング方法を研究しました。このトレーニング方法は受験生の皆さんに短い時間で予期の成果を取らせます。特に仕事しながら勉強している受験生たちにとって不可欠なツールです。NewValidDumpsトレーニング資料を選んだら、あなたは自分の夢を実現できます。

あなたは弊社の高品質Cisco　350-401認証資格試験資料を利用して、一回に試験に合格します。NewValidDumpsのCisco　350-401認証資格問題集は専門家たちが数年間で過去のデータから分析して作成されて、試験にカバーする範囲は広くて、受験生の皆様のお金と時間を節約します。

350-401 PDF DEMO:

QUESTION NO: 1
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

Microsoft MS-700-KR - 業種別の人々は自分が将来何か成績を作るようにずっと努力しています。 努力すれば報われますなので、Cisco　CompTIA CAS-004-JPN資格認定を取得して自分の生活状況を改善できます。 EMC D-PWF-OE-P-00 - 受験生の皆さんを試験に合格させることを旨とするだけでなく、皆さんに最高のサービスを提供することも目標としています。 多分、PMI PMI-RMPテスト質問の数が伝統的な問題の数倍である。 ISACA CISA - 国際的に認可された資格として、Ciscoの認定試験を受ける人も多くなっています。

Updated: May 28, 2022