我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。NewValidDumps Ciscoの350-401入門知識試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。インターネットで時勢に遅れない350-401入門知識勉強資料を提供するというサイトがあるかもしれませんが、NewValidDumpsはあなたに高品質かつ最新のCiscoの350-401入門知識トレーニング資料を提供するユニークなサイトです。 あなた達はNewValidDumpsの商品を購入してもっともはやく正確に試験に関する情報を手に入れます。NewValidDumpsの商品は試験問題を広くカーバして、認証試験の受験生が便利を提供し、しかも正確率100%です。 NewValidDumpsが提供したCiscoの350-401入門知識トレーニング資料を利用したら、Ciscoの350-401入門知識認定試験に受かることはたやすくなります。

その中で、350-401入門知識認定試験は最も重要な一つです。

Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)入門知識「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の認証試験はあなたがIT分野のプロフェッショナルになることにヘルプを差し上げます。 NewValidDumpsのCiscoの350-401 日本語受験教科書試験トレーニング資料を使ったら、君のCiscoの350-401 日本語受験教科書認定試験に合格するという夢が叶えます。なぜなら、それはCiscoの350-401 日本語受験教科書認定試験に関する必要なものを含まれるからです。

Ciscoの350-401入門知識認定試験を受けることを決めたら、NewValidDumpsがそばにいて差し上げますよ。NewValidDumpsはあなたが自分の目標を達成することにヘルプを差し上げられます。あなたがCiscoの350-401入門知識「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認定試験に合格する需要を我々はよく知っていますから、あなたに高品質の問題集と科学的なテストを提供して、あなたが気楽に認定試験に受かることにヘルプを提供するのは我々の約束です。

Cisco 350-401入門知識 - それは正確性が高くて、カバー率も広いです。

NewValidDumpsが提供したCiscoの350-401入門知識トレーニング資料を持っていたら、美しい未来を手に入れるということになります。NewValidDumpsが提供したCiscoの350-401入門知識トレーニング資料はあなたの成功への礎になれることだけでなく、あなたがIT業種でもっと有効な能力を発揮することも助けられます。このトレーニングはカバー率が高いですから、あなたの知識を豊富させる以外、操作レベルを高められます。もし今あなたがCiscoの350-401入門知識「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験にどうやって合格することに困っているのなら、心配しないでください。NewValidDumpsが提供したCiscoの350-401入門知識トレーニング資料はあなたの問題を解決することができますから。

もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoの350-401入門知識試験のソフトウェアです。我々はあなたに提供するのは最新で一番全面的なCiscoの350-401入門知識問題集で、最も安全な購入保障で、最もタイムリーなCiscoの350-401入門知識試験のソフトウェアの更新です。

350-401 PDF DEMO:

QUESTION NO: 1
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 2
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

現在、市場でオンラインのCiscoのSAP C_TFG51_2405試験トレーニング資料はたくさんありますが、NewValidDumpsのCiscoのSAP C_TFG51_2405試験トレーニング資料は絶対に最も良い資料です。 CiscoのOracle 1Z0-1194-24の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoのOracle 1Z0-1194-24試験に一番信頼できるヘルプを提供します。 USGBC LEED-AP-BD-C - NewValidDumpsのトレーニング資料を選んだら、あなたは一生で利益を受けることができます。 SAP C-C4H63-2411 - 社会と経済の発展につれて、多くの人はIT技術を勉強します。 SAP C-THR81-2405 - 一番遠いところへ行った人はリスクを背負うことを恐れない人です。

Updated: May 28, 2022