人生にはあまりにも多くの変化および未知の誘惑がありますから、まだ若いときに自分自身のために強固な基盤を築くべきです。あなた準備しましたか。NewValidDumpsのCiscoの350-401勉強資料試験トレーニング資料は最高のトレーニング資料です。 弊社のNewValidDumpsは最大なるIT試験のための資料庫ですので、ほかの試験に興味があるなら、NewValidDumpsで探したり、弊社の係員に問い合わせたりすることができます。心よりご成功を祈ります。 そうすると、あなたがいつでも最新バージョンの資料を持っていることが保証されます。

Ciscoの350-401勉強資料試験に合格するのは最良の方法の一です。

あるいは、無料で試験350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)勉強資料問題集を更新してあげるのを選択することもできます。 我々の提供するソフトはこの要求をよく満たして専門的な解答の分析はあなたの理解にヘルプを提供できます。Ciscoの350-401 入門知識試験の資料のいくつかのバーションのデモは我々のウェブサイトで無料でダウンロードできます。

なぜ受験生のほとんどはNewValidDumpsを選んだのですか。それはNewValidDumpsがすごく便利で、広い通用性があるからです。NewValidDumpsのITエリートたちは彼らの専門的な目で、最新的なCiscoの350-401勉強資料試験トレーニング資料に注目していて、うちのCiscoの350-401勉強資料問題集の高い正確性を保証するのです。

Cisco 350-401勉強資料 - 正しい方法は大切です。

花に欺く言語紹介より自分で体験したほうがいいです。Cisco　350-401勉強資料問題集は我々NewValidDumpsでは直接に無料のダウンロードを楽しみにしています。弊社の経験豊かなチームはあなたに最も信頼性の高いCisco　350-401勉強資料問題集備考資料を作成して提供します。Cisco　350-401勉強資料問題集の購買に何か質問があれば、我々の職員は皆様のお問い合わせを待っています。

NewValidDumpsは多くの受験生を助けて彼らにCiscoの350-401勉強資料試験に合格させることができるのは我々専門的なチームがCiscoの350-401勉強資料試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの350-401勉強資料試験の資料を更新し続けています。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

それで、弊社の質高いSAP E-BW4HANA214試験資料を薦めさせてください。 その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調にMicrosoft DP-203-KR向けの会社に入ります。 私たちのJuniper JN0-231参考資料は十年以上にわたり、専門家が何度も練習して、作られました。 我々Microsoft MS-900-JPN問題集の通過率は高いので、90％の合格率を保証します。 HP HPE7-A02 - 弊社の無料なサンプルを遠慮なくダウンロードしてください。

Updated: May 28, 2022