あるいは、他の科目の試験を変えていいです。我々NewValidDumpsでは、あなたは一番優秀なCisco　350-401ファンデーション問題集を発見できます。我が社のサービスもいいです。 数年以来の整理と分析によって開発された350-401ファンデーション問題集は権威的で全面的です。350-401ファンデーション問題集を利用して試験に合格できます。 試験にパースする原因は我々問題集の全面的で最新版です。

CCNP Enterprise 350-401 もし合格しないと、われは全額で返金いたします。

CCNP Enterprise 350-401ファンデーション - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) あなたに向いていることを確かめてから買うのも遅くないですよ。 専門的な知識が必要で、もしあなたはまだこの方面の知識を欠かれば、NewValidDumpsは君に向ける知識を提供いたします。NewValidDumpsの専門家チームは彼らの知識や経験を利用してあなたの知識を広めることを助けています。

NewValidDumpsはとても良い選択で、350-401ファンデーションの試験を最も短い時間に縮められますから、あなたの費用とエネルギーを節約することができます。それに、あなたに美しい未来を作ることに助けを差し上げられます。Ciscoの350-401ファンデーション認定試験に受かるのはあなたの技能を検証することだけでなく、あなたの専門知識を証明できて、上司は無駄にあなたを雇うことはしないことの証明書です。

Cisco 350-401ファンデーション - ここには、私たちは君の需要に応じます。

NewValidDumpsのCiscoの350-401ファンデーション試験トレーニング資料は必要とするすべての人に成功をもたらすことができます。Ciscoの350-401ファンデーション試験は挑戦がある認定試験です。現在、書籍の以外にインターネットは知識の宝庫として見られています。NewValidDumps で、あなたにあなたの宝庫を見つけられます。NewValidDumps はCiscoの350-401ファンデーション試験に関連する知識が全部含まれていますから、あなたにとって難しい問題を全て解決して差し上げます。

うちのCiscoの350-401ファンデーション試験トレーニング資料を購入する前に、NewValidDumpsのサイトで、一部分のフリーな試験問題と解答をダンロードでき、試用してみます。君がうちの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

SAP C-TS414-2021-JPN - 購入する前に、あなたはNewValidDumpsが提供した無料な一部の問題と解答をダウンロードして使ってみることができます。 我々の目的はあなたにCiscoのServiceNow CIS-VR試験に合格することだけです。 Microsoft MB-500 - NewValidDumpsの製品を購入したら、あなたはいつでも最新かつ最正確な試験情報を得ることができます。 CiscoのHuawei H19-462_V1.0試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはCiscoのHuawei H19-462_V1.0試験に合格することができます。 Fortinet FCP_ZCS_AD-7.4 - これはCiscoの最も重要な試験の一つで、業界全体に認証された資格です。

Updated: May 28, 2022