NewValidDumpsは多種なIT認証試験を受ける方を正確な資料を提供者でございます。弊社の無料なサンプルを遠慮なくダウンロードしてください。 努力すれば報われますなので、Cisco　350-401オンライン試験資格認定を取得して自分の生活状況を改善できます。IT職員のあなたは毎月毎月のあまり少ない給料を持っていますが、暇の時間でひたすら楽しむんでいいですか。 こうして、弊社の商品はどのくらいあなたの力になるのはよく分かっています。

CCNP Enterprise 350-401 きっと君に失望させないと信じています。

Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)オンライン試験認証試験を選んだ人々が一層多くなります。 我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。NewValidDumps Ciscoの350-401 赤本勉強試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。

この試験は本当に難しいことがみんなは良く知っていますが、試験に受かるのは不可能ではないです。自分に向いている勉強ツールを選べますから。NewValidDumps のCiscoの350-401オンライン試験試験問題集と解答はあなたにとって一番良い選択です。

Cisco 350-401オンライン試験 - 頑張ってください。

IT認定試験の中でどんな試験を受けても、NewValidDumpsの350-401オンライン試験試験参考資料はあなたに大きなヘルプを与えることができます。それは NewValidDumpsの350-401オンライン試験問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。真剣にNewValidDumpsのCisco 350-401オンライン試験問題集を勉強する限り、受験したい試験に楽に合格することができるということです。

この問題集は利用したそれぞれの人を順調に試験に合格させます。もちろん、これはあなたが全然努力する必要がないという意味ではありません。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 4
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

その中で、EMC D-NWG-DS-00認定試験は最も重要な一つです。 それに、より効率的に試験の準備をするために、NewValidDumpsのScrum SSM-JPN試験問題集を選択したほうがいいです。 VMware 2V0-41.24-JPN - まだ何を待っていますか。 CIPS L4M5認定試験は現在で本当に人気がある試験ですね。 Microsoft SC-400J - それは正確性が高くて、カバー率も広いです。

Updated: May 28, 2022