NewValidDumpsにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 350-401参考書認証試験に参加する方に対して問題集を研究続けています。君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにNewValidDumpsを選択してください。NewValidDumpsはまた一年間に無料なサービスを更新いたします。 NewValidDumpsは君の試験に合格させるだけでなく本当の知識を学ばれます。NewValidDumpsはあなたが100% で350-401参考書試験に合格させるの保証することができてまたあなたのために一年の無料の試験の練習問題と解答の更新サービス提供して、もし試験に失敗したら、弊社はすぐ全額で返金を保証いたします。 NewValidDumps のCiscoの350-401参考書問題集はシラバスに従って、それに350-401参考書認定試験の実際に従って、あなたがもっとも短い時間で最高かつ最新の情報をもらえるように、弊社はトレーニング資料を常にアップグレードしています。

CCNP Enterprise 350-401 NewValidDumpsには専門的なエリート団体があります。

そうしたらあなたがCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)参考書認定試験にもっと自信を増加して、もし失敗したら、全額で返金いたします。 NewValidDumpsのCiscoの350-401 参考資料試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。それはあなたがいつでも最新の試験資料を持てるということです。

もし弊社のCiscoの350-401参考書「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験について問題集に興味があったら、購入するまえにインターネットで弊社が提供した無料な部分問題集をダウンロードして、君の試験に役に立つかどうかのを自分が判断してください。それにNewValidDumpsは一年の無料な更新のサービスを提供いたします。

Cisco 350-401参考書 - 正しい方法は大切です。

偉大な事業を実現するために信心を持つ必要があります。あなたは自分の知識レベルを疑っていて試験の準備をする前に詰め込み勉強しているときに、自分がどうやって試験に受かることを確保するかを考えましたか。心配しないでください。NewValidDumpsはあなたがCiscoの350-401参考書認定試験に合格する確保です。NewValidDumps のトレーニング試験は問題と解答に含まれています。しかも１００パーセントの合格率を保証できます。NewValidDumpsのCiscoの350-401参考書試験トレーニング資料を手に入れたら、あなたは自分の第一歩を進めることができます。試験に合格してから、あなたのキャリアは美しい時期を迎えるようになります。

NewValidDumpsは多くの受験生を助けて彼らにCiscoの350-401参考書試験に合格させることができるのは我々専門的なチームがCiscoの350-401参考書試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの350-401参考書試験の資料を更新し続けています。

350-401 PDF DEMO:

QUESTION NO: 1
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 3
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

CompTIA CAS-004-JPN - そうすると、受験するとき、あなたは試験を容易に対処することができます。 その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調にVMware 5V0-43.21向けの会社に入ります。 Microsoft AZ-801 - これは試験の一発合格を保証できる問題集ですから。 我々SAP C_THR86_2405問題集の通過率は高いので、90％の合格率を保証します。 VMware 2V0-71.23-JPN - この二つのバージョンを利用して、受験生の皆さんは試験の準備をするときにもっと楽になることができます。

Updated: May 28, 2022