あなたにCisco　642-997資格参考書試験に関する最新かつ最完備の資料を勉強させ、試験に合格させることだと信じます。もしあなたは642-997資格参考書試験に合格しなかったら、全額返金のことを承諾します。我々NewValidDumpsは一番行き届いたアフタサービスを提供します。 NewValidDumpsが提供した研修ツールはCiscoの642-997資格参考書の認定試験に向けて学習資料やシミュレーション訓練宿題で、重要なのは試験に近い練習問題と解答を提供いたします。NewValidDumps を選ばれば短時間にITの知識を身につけることができて、高い点数をとられます。 周りの多くの人は全部Cisco　642-997資格参考書資格認定試験にパースしまして、彼らはどのようにできましたか。

CCNP Data Center 642-997 最もよくて最新で資料を提供いたします。

NewValidDumpsのガイダンスとヘルプを通して、初めにCiscoの642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)資格参考書「Implementing Cisco Data Center Unified Fabric (DCUFI)」の認証を受けるあなたは、気楽に試験に合格すことができます。 Cisco 642-997 参考資料「Implementing Cisco Data Center Unified Fabric (DCUFI)」認証試験に合格することが簡単ではなくて、Cisco 642-997 参考資料証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。

その中で、NewValidDumpsが他のサイトをずっと先んじてとても人気があるのは、NewValidDumpsのCiscoの642-997資格参考書試験トレーニング資料が本当に人々に恩恵をもたらすことができて、速く自分の夢を実現することにヘルプを差し上げられますから。642-997資格参考書認定試験はIT業界の新たなターニングポイントの一つです。試験に受かったら、あなたはIT業界のエリートになることができます。

Cisco 642-997資格参考書 - あなたに絶対向いていると信じていますよ。

NewValidDumpsは実際の環境で本格的なCiscoの642-997資格参考書「Implementing Cisco Data Center Unified Fabric (DCUFI)」の試験の準備過程を提供しています。もしあなたは初心者若しくは専門的な技能を高めたかったら、NewValidDumpsのCiscoの642-997資格参考書「Implementing Cisco Data Center Unified Fabric (DCUFI)」の試験問題があなたが一歩一歩自分の念願に近くために助けを差し上げます。試験問題と解答に関する質問があるなら、当社は直後に解決方法を差し上げます。しかも、一年間の無料更新サービスを提供します。

IT認証はIT業種での競争な手段の一つです。認証に受かったらあなたは各方面でよく向上させます。

642-997 PDF DEMO:

QUESTION NO: 1
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 2
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 3
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

QUESTION NO: 4
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 5
If vPC peer keepalives are used between vPC peers, which VRF is used by default?
A. management
B. default
C. The user must dedicate a VRF for keepalives.
D. system
Answer: A

NewValidDumpsのCiscoのCisco 300-445試験問題資料は質が良くて値段が安い製品です。 IBM C1000-181 - 難しいIT認証試験に受かることを選んだら、頑張って準備すべきです。 NewValidDumpsのCiscoのIAPP CIPT試験トレーニング資料はIT人員の皆さんがそんな目標を達成できるようにヘルプを提供して差し上げます。 IAM IAM-Certificate - NewValidDumpsのトレーニング資料を手に入れたら、あなたは成功への鍵を握るようになります。 HP HPE7-A02 - 私の夢は最高のIT専門家になることです。

Updated: May 28, 2022