弊社の642-997復習範囲問題集は大勢の専門家たちの努力で開発される成果です。初心者といい、数年IT仕事を従事した人といい、我々NewValidDumpsのCisco　642-997復習範囲問題集は最良の選択であると考えられます。なぜならば、弊社は高品質かつ改革によってすぐに更新できる642-997復習範囲問題集を提供できるからです。 Ciscoの642-997復習範囲認定試験に受かるのはあなたの技能を検証することだけでなく、あなたの専門知識を証明できて、上司は無駄にあなたを雇うことはしないことの証明書です。当面、IT業界でCiscoの642-997復習範囲認定試験の信頼できるソースが必要です。 短い時間で642-997復習範囲資格認定を取得するような高いハイリターンは嬉しいことではないでしょうか。

それはNewValidDumpsの642-997復習範囲問題集です。

もしあなたはまだ合格のためにCisco 642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)復習範囲に大量の貴重な時間とエネルギーをかかって一生懸命準備し、Cisco 642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)復習範囲「Implementing Cisco Data Center Unified Fabric (DCUFI)」認証試験に合格するの近道が分からなくって、今はNewValidDumpsが有効なCisco 642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)復習範囲認定試験の合格の方法を提供して、君は半分の労力で倍の成果を取るの与えています。 一回だけでCiscoの642-997 テストトレーニング試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。NewValidDumpsは君にとってベストな選択になります。

Ciscoの642-997復習範囲試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でNewValidDumpsは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。

Cisco 642-997復習範囲 - 我々の誠意を信じてください。

購入前にNewValidDumpsが提供した無料の問題集をダウンロードできます。自分の練習を通して、試験のまえにうろたえないでしょう。NewValidDumpsを選択して専門性の訓練が君の試験によいだと思います。

自分のIT業界での発展を希望したら、Ciscoの642-997復習範囲試験に合格する必要があります。Ciscoの642-997復習範囲試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはCiscoの642-997復習範囲試験に合格することができます。

642-997 PDF DEMO:

QUESTION NO: 1
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 2
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 3
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 4
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 5
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

APM APM-PFQ - もし君はまだIT試験で心配すれば、私達NewValidDumpsの問題集を選んでください。 あなたは自分の望ましいCisco Cisco 300-430J問題集を選らんで、学びから更なる成長を求められます。 すべてのCiscoのSAP P_SAPEA_2023試験は非常に重要ですが、こんな情報技術が急速に発展している時代に、NewValidDumpsはただその中の一つです。 短時間でFortinet NSE7_SDW-7.2試験に一発合格したいなら、我々社のCiscoのFortinet NSE7_SDW-7.2資料を参考しましょう。 CiscoのCompTIA N10-008試験はNewValidDumpsの保証を検証することができ、１００パーセントの合格率に達することができます。

Updated: May 28, 2022