NewValidDumpsのITエリートたちは彼らの専門的な目で、最新的なCiscoの642-997試験勉強攻略試験トレーニング資料に注目していて、うちのCiscoの642-997試験勉強攻略問題集の高い正確性を保証するのです。もし君はいささかな心配することがあるなら、あなたはうちの商品を購入する前に、NewValidDumpsは無料でサンプルを提供することができます。なぜ受験生のほとんどはNewValidDumpsを選んだのですか。 その他、642-997試験勉強攻略問題集の更新版を無料に提供します。ご客様は弊社の642-997試験勉強攻略問題集を購入するかどうかと判断する前に、我が社は無料に提供するサンプルをダウンロードして試すことができます。 Ciscoの642-997試験勉強攻略認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。

私たちより、642-997試験勉強攻略試験を知る人はいません。

我々642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)試験勉強攻略問題集の通過率は高いので、90％の合格率を保証します。 NewValidDumpsは多種なIT認証試験を受ける方を正確な資料を提供者でございます。弊社の無料なサンプルを遠慮なくダウンロードしてください。

IT職員のあなたは毎月毎月のあまり少ない給料を持っていますが、暇の時間でひたすら楽しむんでいいですか。Cisco　642-997試験勉強攻略試験認定書はIT職員野給料増加と仕事の昇進にとって、大切なものです。それで、我々社の無料のCisco　642-997試験勉強攻略デモを参考して、あなたに相応しい問題集を入手します。

Cisco 642-997試験勉強攻略 - あなた準備しましたか。

IT認定試験の中でどんな試験を受けても、NewValidDumpsの642-997試験勉強攻略試験参考資料はあなたに大きなヘルプを与えることができます。それは NewValidDumpsの642-997試験勉強攻略問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。真剣にNewValidDumpsのCisco 642-997試験勉強攻略問題集を勉強する限り、受験したい試験に楽に合格することができるということです。

あなたがする必要があるのは、問題集に出るすべての問題を真剣に勉強することです。この方法だけで、試験を受けるときに簡単に扱うことができます。

642-997 PDF DEMO:

QUESTION NO: 1
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 2
Which management feature provides these functions?
* Direct paging of network support engineers
* Email notifications to a network operations center
* Direct Service Request generation with the Cisco TAC
A. scripting along with the scheduler feature
B. RSA
C. Call Home
D. SNMP traps
Answer: C

QUESTION NO: 3
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 4
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 5
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

Citrix 1Y0-204 - がむしゃらに試験に関連する知識を勉強しているのですか。 ACAMS CAMS-KR - あまりにも多くのIT認定試験と試験に関連する参考書を見ると、頭が痛いと感じていますか。 Palo Alto Networks PCNSA - 早速買いに行きましょう。 WGU Organizational-Behaviors-and-Leadership - 確かに、これは困難な試験です。 NewValidDumpsのCiscoのVMware 6V0-32.24試験トレーニング資料はCiscoのVMware 6V0-32.24認定試験を準備するのリーダーです。

Updated: May 28, 2022