我々NewValidDumpsがあなたに提供するCiscoの642-997専門トレーリングソフトはこれを保証します。我々の問題集の更新と解答への専門的な分析は我々の商品に多くの受験生の試験に合格する秘密武器にならせます。試験に失敗したら全額d返金するという承諾は我々への励ましです。 あなたは自分の望ましいCisco 642-997専門トレーリング問題集を選らんで、学びから更なる成長を求められます。心はもはや空しくなく、生活を美しくなります。 世界は変化している、我々はできるだけそのペースを維持する必要があります。

CCNP Data Center 642-997 早くNewValidDumpsの問題集を君の手に入れましょう。

Cisco 642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)専門トレーリング試験に合格することは簡単ではなくて、適切な訓练を選ぶのはあなたの成功の第一歩です。 君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにNewValidDumpsを選択してください。NewValidDumpsはまた一年間に無料なサービスを更新いたします。

NewValidDumpsは君の試験に合格させるだけでなく本当の知識を学ばれます。NewValidDumpsはあなたが100% で642-997専門トレーリング試験に合格させるの保証することができてまたあなたのために一年の無料の試験の練習問題と解答の更新サービス提供して、もし試験に失敗したら、弊社はすぐ全額で返金を保証いたします。

Cisco 642-997専門トレーリング - 私の夢は最高のIT専門家になることです。

常々、時間とお金ばかり効果がないです。正しい方法は大切です。我々NewValidDumpsは一番効果的な方法を探してあなたにCiscoの642-997専門トレーリング試験に合格させます。弊社のCiscoの642-997専門トレーリングソフトを購入するのを決めるとき、我々は各方面であなたに保障を提供します。購入した前の無料の試み、購入するときのお支払いへの保障、購入した一年間の無料更新Ciscoの642-997専門トレーリング試験に失敗した全額での返金…これらは我々のお客様への承諾です。

NewValidDumpsはあなたがCiscoの642-997専門トレーリング認定試験に合格する確保です。NewValidDumps のトレーニング試験は問題と解答に含まれています。

642-997 PDF DEMO:

QUESTION NO: 1
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 2
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 3
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 4
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 5
Which management feature provides these functions?
* Direct paging of network support engineers
* Email notifications to a network operations center
* Direct Service Request generation with the Cisco TAC
A. scripting along with the scheduler feature
B. RSA
C. Call Home
D. SNMP traps
Answer: C

NewValidDumpsは多くの受験生を助けて彼らにCiscoのSAP C-TS414-2023試験に合格させることができるのは我々専門的なチームがCiscoのSAP C-TS414-2023試験を研究して解答を詳しく分析しますから。 そして、ソフトウェア版のCisco 200-201J問題集は実際試験の雰囲気を感じさせることができます。 その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調にISTQB CT-AI向けの会社に入ります。 NewValidDumpsのSAP C-TS4FI-2023試験参考書は他のSAP C-TS4FI-2023試験に関連するする参考書よりずっと良いです。 我々Huawei H20-421_V1.0問題集の通過率は高いので、90％の合格率を保証します。

Updated: May 28, 2022