NewValidDumpsの試験問題集を手にすると、どのような試験でも問題ではありません。Ciscoの642-997試験資料認定試験を除いて、最近非常に人気がある試験はまたCisco、Cisco、IBM、SAPなどの様々な認定試験があります。しかし、もし642-997試験資料認証資格を取りたいなら、NewValidDumpsの642-997試験資料問題集はあなたを願望を達成させることができます。 なぜ受験生のほとんどはNewValidDumpsを選んだのですか。それはNewValidDumpsがすごく便利で、広い通用性があるからです。 もしこの問題集を利用してからやはり試験に不合格になってしまえば、NewValidDumpsは全額で返金することができます。

CCNP Data Center 642-997 君は成功の道にもっと近くなります。

弊社のCiscoの642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)試験資料ソフトを購入するのを決めるとき、我々は各方面であなたに保障を提供します。 NewValidDumpsを選ぶなら、輝い未来を選ぶのに等しいです。まだCiscoの642-997 関連資格知識認定試験に合格できるかどうかを悩んでいますか。

NewValidDumpsは多くの受験生を助けて彼らにCiscoの642-997試験資料試験に合格させることができるのは我々専門的なチームがCiscoの642-997試験資料試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの642-997試験資料試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。

Cisco 642-997試験資料 - NewValidDumpsはあなたの信頼を得る足ります。

IT職員のあなたは毎月毎月のあまり少ない給料を持っていますが、暇の時間でひたすら楽しむんでいいですか。Cisco　642-997試験資料試験認定書はIT職員野給料増加と仕事の昇進にとって、大切なものです。それで、我々社の無料のCisco　642-997試験資料デモを参考して、あなたに相応しい問題集を入手します。暇の時間を利用して勉強します。努力すれば報われますなので、Cisco　642-997試験資料資格認定を取得して自分の生活状況を改善できます。

これはあなたの能力を認めます。Ciscoの642-997試験資料試験のほかの認証試験も大切なのです。

642-997 PDF DEMO:

QUESTION NO: 1
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 2
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

QUESTION NO: 3
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 4
If vPC peer keepalives are used between vPC peers, which VRF is used by default?
A. management
B. default
C. The user must dedicate a VRF for keepalives.
D. system
Answer: A

QUESTION NO: 5
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

そして、IBM C1000-156試験参考書の問題は本当の試験問題とだいたい同じことであるとわかります。 CheckPoint 156-315.81 - 時間が経つとともに、我々はインタネット時代に生活します。 Huawei H23-211_V1.0 - この試験に合格すれば君の専門知識がとても強いを証明し得ます。 あなたは十分の時間でCheckPoint 156-215.81.20試験を準備することができます。 きみはCiscoのTableau TDA-C01-JPN認定テストに合格するためにたくさんのルートを選択肢があります。

Updated: May 28, 2022