それは正確性が高くて、カバー率も広いです。あなたはNewValidDumpsの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。NewValidDumpsのCiscoの642-997受験練習参考書試験トレーニング資料はCiscoの642-997受験練習参考書認定試験を準備するのリーダーです。 NewValidDumpsは多くのIT職員の夢を達成することであるウェブサイトです。IT夢を持っていたら、速くNewValidDumpsに来ましょう。 無料デモはあなたに安心で購入して、購入した後1年間の無料Ciscoの642-997受験練習参考書試験の更新はあなたに安心で試験を準備することができます、あなたは確実に購入を休ませることができます私たちのソフトウェアを試してみてください。

CCNP Data Center 642-997 あなたに一年間の無料更新サービスを提供します。

Cisco 642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)受験練習参考書「Implementing Cisco Data Center Unified Fabric (DCUFI)」認証試験に合格することが簡単ではなくて、Cisco 642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)受験練習参考書証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。 アフターサービスは会社を評価する重要な基準です。これをよくできるために、我々は全日24時間のサービスを提供します。

今の社会の中で、ネット上で訓練は普及して、弊社は試験問題集を提供する多くのネットの一つでございます。NewValidDumpsが提供したのオンライン商品がIT業界では品質の高い学習資料、受験生の必要が満足できるサイトでございます。

Cisco 642-997受験練習参考書 - すべてのバーションは無料のデモを提供します。

NewValidDumpsは実際の環境で本格的なCiscoの642-997受験練習参考書「Implementing Cisco Data Center Unified Fabric (DCUFI)」の試験の準備過程を提供しています。もしあなたは初心者若しくは専門的な技能を高めたかったら、NewValidDumpsのCiscoの642-997受験練習参考書「Implementing Cisco Data Center Unified Fabric (DCUFI)」の試験問題があなたが一歩一歩自分の念願に近くために助けを差し上げます。試験問題と解答に関する質問があるなら、当社は直後に解決方法を差し上げます。しかも、一年間の無料更新サービスを提供します。

返金を願うのに対して、お客様は642-997受験練習参考書に合格しない成績書を弊社に送付して、弊社は確認の後、支払い金額を全部返済します。初心者にとって、642-997受験練習参考書試験に合格するのはそんなに難しいことですか？実は、我々NewValidDumpsの642-997受験練習参考書問題集を選んで利用し、お客様は力の限りまで勉強して、合格しやすいです。

642-997 PDF DEMO:

QUESTION NO: 1
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 2
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

QUESTION NO: 3
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 4
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 5
If vPC peer keepalives are used between vPC peers, which VRF is used by default?
A. management
B. default
C. The user must dedicate a VRF for keepalives.
D. system
Answer: A

NewValidDumpsのCiscoのHP HP2-I73試験問題資料は質が良くて値段が安い製品です。 我々社NewValidDumpsは試験政策の変化に応じて、CiscoのMicrosoft AZ-400J問題集をタイムリーに更新しています。 WELL WELL-AP - 優れたキャリアを持ったら、社会と国のために色々な利益を作ることができて、国の経済が継続的に発展していることを進められるようになります。 弊社の誠意を信じてもらいたいし、Cisco　Amazon SAA-C03-JPN試験2成功するのを祈って願います。 EC-COUNCIL 312-38 - その夢は私にとってはるか遠いです。

Updated: May 28, 2022