NewValidDumpsのCiscoの642-997関連試験試験トレーニング資料はインターネットでの全てのトレーニング資料のリーダーです。NewValidDumpsはあなたが首尾よく試験に合格することを助けるだけでなく、あなたの知識と技能を向上させることもできます。あなたが自分のキャリアでの異なる条件で自身の利点を発揮することを助けられます。 我々NewValidDumpsは642-997関連試験試験の難しさを減らないとは言え、試験準備の難しさを減ることができます。我々の提供する問題集を体験してから、あなたはCiscoの642-997関連試験試験に合格できる自信を持っています。 また、NewValidDumpsのCiscoの642-997関連試験試験トレーニング資料が信頼できるのは多くの受験生に証明されたものです。

CCNP Data Center 642-997 まだ何を待っていますか。

次のジョブプロモーション、プロジェクタとチャンスを申し込むとき、Cisco　642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)関連試験資格認定はライバルに先立つのを助け、あなたの大業を成し遂げられます。 それは正確性が高くて、カバー率も広いです。あなたはNewValidDumpsの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

つまり642-997関連試験練習問題はあなたの最も正しい選択です。あなたは今やはり642-997関連試験試験に悩まされていますか？長い時間642-997関連試験試験を取り組んいる弊社はあなたに642-997関連試験練習問題を提供できます。あなたは642-997関連試験試験に興味を持たれば、今から行動し、642-997関連試験練習問題を買いましょう。

だから、Cisco 642-997関連試験復習教材を買いました。

我々の承諾だけでなく、お客様に最も全面的で最高のサービスを提供します。Ciscoの642-997関連試験の購入の前にあなたの無料の試しから、購入の後での一年間の無料更新まで我々はあなたのCiscoの642-997関連試験試験に一番信頼できるヘルプを提供します。Ciscoの642-997関連試験試験に失敗しても、我々はあなたの経済損失を減少するために全額で返金します。

あなたはその他のCisco 642-997関連試験「Implementing Cisco Data Center Unified Fabric (DCUFI)」認証試験に関するツールサイトでも見るかも知れませんが、弊社はIT業界の中で重要な地位があって、NewValidDumpsの問題集は君に100%で合格させることと君のキャリアに変らせることだけでなく一年間中で無料でサービスを提供することもできます。

642-997 PDF DEMO:

QUESTION NO: 1
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 2
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 3
Which management feature provides these functions?
* Direct paging of network support engineers
* Email notifications to a network operations center
* Direct Service Request generation with the Cisco TAC
A. scripting along with the scheduler feature
B. RSA
C. Call Home
D. SNMP traps
Answer: C

QUESTION NO: 4
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 5
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

Cisco 300-420J - 社会と経済の発展につれて、多くの人はIT技術を勉強します。 NewValidDumpsを通じて最新のCiscoのSalesforce Manufacturing-Cloud-Professional試験の問題と解答早めにを持てて、弊社の問題集があればきっと君の強い力になります。 あなたにCisco　HP HPE0-V28-KR試験に関する最新かつ最完備の資料を勉強させ、試験に合格させることだと信じます。 NewValidDumpsが提供した研修ツールはCiscoのSplunk SPLK-2003の認定試験に向けて学習資料やシミュレーション訓練宿題で、重要なのは試験に近い練習問題と解答を提供いたします。 周りの多くの人は全部Cisco　SAP C-CPI-2404資格認定試験にパースしまして、彼らはどのようにできましたか。

Updated: May 28, 2022