人によって目標が違いますが、あなたにCisco　350-401資格専門知識試験に順調に合格できるのは我々の共同の目標です。この目標の達成はあなたがIT技術領域へ行く更なる発展の一歩ですけど、我々社NewValidDumps存在するこそすべての意義です。だから、我々社は力の限りで弊社のCisco　350-401資格専門知識試験資料を改善し、改革の変更に応じて更新します。 うちのCiscoの350-401資格専門知識学習教材はNewValidDumpsのIT専門家たちが研究して、実践して開発されたものです。それは十年過ぎのIT認証経験を持っています。 あなたに高品質で、全面的な350-401資格専門知識参考資料を提供することは私たちの責任です。

CCNP Enterprise 350-401 あなたが安心で試験のために準備すればいいです。

CCNP Enterprise 350-401資格専門知識 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 早くNewValidDumpsの問題集を君の手に入れましょう。 我々NewValidDumpsが自分のソフトに自信を持つのは我々のCiscoの350-401 試験関連情報ソフトでCiscoの350-401 試験関連情報試験に参加する皆様は良い成績を取りましたから。Ciscoの350-401 試験関連情報試験に合格して彼らのよりよい仕事を探せるチャンスは多くなります。

NewValidDumpsにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 350-401資格専門知識認証試験に参加する方に対して問題集を研究続けています。君が後悔しないようにもっと少ないお金を使って大きな良い成果を取得するためにNewValidDumpsを選択してください。NewValidDumpsはまた一年間に無料なサービスを更新いたします。

Cisco 350-401資格専門知識問題集を利用して試験に合格できます。

IT技術の急速な発展につれて、IT認証試験の問題は常に変更されています。したがって、NewValidDumpsの350-401資格専門知識問題集も絶えずに更新されています。それに、NewValidDumpsの教材を購入すれば、NewValidDumpsは一年間の無料アップデート・サービスを提供してあげます。問題が更新される限り、NewValidDumpsは直ちに最新版の350-401資格専門知識資料を送ってあげます。そうすると、あなたがいつでも最新バージョンの資料を持っていることが保証されます。NewValidDumpsはあなたが試験に合格するのを助けることができるだけでなく、あなたは最新の知識を学ぶのを助けることもできます。このような素晴らしい資料をぜひ見逃さないでください。

そのため、350-401資格専門知識試験参考書に対して、お客様の新たな要求に迅速に対応できます。それは受験者の中で、350-401資格専門知識試験参考書が人気がある原因です。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

あるいは、無料で試験Microsoft MB-920問題集を更新してあげるのを選択することもできます。 Salesforce Sales-Cloud-Consultant-JPN - NewValidDumpsはもっぱら認定試験に参加するIT業界の専門の人士になりたい方のために模擬試験の練習問題と解答を提供した評判の高いサイトでございます。 Okta Okta-Certified-Consultant - なぜ受験生のほとんどはNewValidDumpsを選んだのですか。 Esri EUNS20-001 - 給料もほかの人と比べて高くて仕事の内容も豊富です。 NewValidDumpsのCiscoのMicrosoft AI-900問題集を購入するなら、君がCiscoのMicrosoft AI-900認定試験に合格する率は１００パーセントです。

Updated: May 28, 2022