NewValidDumpsのCiscoの350-401受験体験試験問題資料は質が良くて値段が安い製品です。我々は低い価格と高品質の模擬問題で受験生の皆様に捧げています。我々は心からあなたが首尾よく試験に合格することを願っています。 NewValidDumpsの専門家チームが彼ら自分の知識と経験を使って多くの人の夢が実現させるIT関連の認証試験の問題集を研究し続けています。NewValidDumpsが提供したCiscoの350-401受験体験試験問題と解答が真実の試験の練習問題と解答は最高の相似性があります。 NewValidDumpsのCiscoの350-401受験体験試験トレーニング資料はIT人員の皆さんがそんな目標を達成できるようにヘルプを提供して差し上げます。

CCNP Enterprise 350-401 自分がやっていることに満足していますか。

我々の提供するPDF版のCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)受験体験試験の資料はあなたにいつでもどこでも読めさせます。 実際にはそれは全く不要です。IT認定試験はあなたの思い通りに神秘的なものではありません。

我々NewValidDumpsはCiscoの350-401受験体験試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の350-401受験体験試験問題集を開発するのに準備します。

はやくNewValidDumpsのCisco 350-401受験体験問題集を入手しましょう。

競争力が激しい社会に当たり、我々NewValidDumpsは多くの受験生の中で大人気があるのは受験生の立場からCisco　350-401受験体験試験資料をリリースすることです。たとえば、ベストセラーのCisco　350-401受験体験問題集は過去のデータを分析して作成ます。ほんとんどお客様は我々NewValidDumpsのCisco　350-401受験体験問題集を使用してから試験にうまく合格しましたのは弊社の試験資料の有効性と信頼性を説明できます。

NewValidDumpsのCiscoの350-401受験体験の試験問題と解答は当面の市場で最も徹底的な正確的な最新的な模擬テストです。煩わしいCiscoの350-401受験体験試験問題で、悩んでいますか？悩むことはありません。

350-401 PDF DEMO:

QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

この問題集の合格率は高いので、多くのお客様からMicrosoft DP-600問題集への好評をもらいました。 NewValidDumpsのCiscoのPECB ISO-22301-Lead-Implementer試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。 Huawei H12-831_V1.0 - NewValidDumpsは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。 もしNewValidDumpsのCiscoのPECB ISO-IEC-27001-Lead-Auditor-CN試験トレーニング資料を購入した後、学習教材は問題があれば、或いは試験に不合格になる場合は、私たちが全額返金することを保証いたします。 CiscoのSAP C_S4CPR_2408試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でNewValidDumpsは君の試験の問題を準備してしまいました。

Updated: May 28, 2022