NewValidDumpsの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoの350-401試験時間認定試験対策模擬テスト問題集が研究しました。模擬テスト問題集と真実の試験問題がよく似ています。一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。 我々の商品にあなたを助けさせましょう。チャンスはいつも準備がある人のために存在しています。 あなたはいつでもサブスクリプションの期間を延長することができますから、より多くの時間を取って充分に試験を準備できます。

CCNP Enterprise 350-401 だから、私たちは信頼されるに値します。

350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)試験時間認定試験に合格することは難しいようですね。 もしあなたはまだ合格のためにCisco 350-401 試験解説に大量の貴重な時間とエネルギーをかかって一生懸命準備し、Cisco 350-401 試験解説「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格するの近道が分からなくって、今はNewValidDumpsが有効なCisco 350-401 試験解説認定試験の合格の方法を提供して、君は半分の労力で倍の成果を取るの与えています。

ここには、私たちは君の需要に応じます。NewValidDumpsのCiscoの350-401試験時間問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。もし不合格になったら、私たちは全額返金することを保証します。

Cisco 350-401試験時間 - 君の初めての合格を目標にします。

NewValidDumpsのCiscoの350-401試験時間試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。その権威性は言うまでもありません。うちのCiscoの350-401試験時間試験トレーニング資料を購入する前に、NewValidDumpsのサイトで、一部分のフリーな試験問題と解答をダンロードでき、試用してみます。君がうちの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

IT業界ではさらに強くなるために強い専門知識が必要です。多くの人々は高い難度のIT認証試験に合格するのは専門の知識が必要だと思います。

350-401 PDF DEMO:

QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

Oracle 1z1-071-JPN - 時間とお金の集まりより正しい方法がもっと大切です。 Peoplecert ITIL-4-Specialist-High-velocity-IT - 自分の練習を通して、試験のまえにうろたえないでしょう。 CiscoのSAP C_THR97_2411試験を準備しているあなたに試験に合格させるために、我々NewValidDumpsは模擬試験ソフトを更新し続けています。 SAP P_C4H34_2411 - それは確かに君の試験に役に立つとみられます。 SAP C-HRHPC-2411 - 世の中に去年の自分より今年の自分が優れていないのは立派な恥です。

Updated: May 28, 2022