心配することはないよ、NewValidDumpsのCiscoの350-401試験復習赤本試験トレーニング資料がありますから。この資料を手に入れたら、全てのIT認証試験がたやすくなります。NewValidDumpsのCiscoの350-401試験復習赤本試験トレーニング資料はCiscoの350-401試験復習赤本認定試験のリーダーです。 そうしたらあなたはNewValidDumpsが用意した問題集にもっと自信があります。早くNewValidDumpsの問題集を君の手に入れましょう。 運命は自分の手にあることを忘れないでください。

CCNP Enterprise 350-401 できるだけ100％の通過率を保証使用にしています。

ブームになるIT技術業界でも、多くの人はこういう悩みがあるんですから、Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)試験復習赤本の能力を把握できるのは欠かさせないない技能であると考えられます。 ただ、社会に入るIT卒業生たちは自分能力の不足で、350-401 資格認定試験向けの仕事を探すのを悩んでいますか？それでは、弊社のCiscoの350-401 資格認定練習問題を選んで実用能力を速く高め、自分を充実させます。その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調に350-401 資格認定向けの会社に入ります。

我々社のCisco　350-401試験復習赤本問題集を購入するかどうかと疑問があると、弊社NewValidDumpsの350-401試験復習赤本問題集のサンプルをしてみるのもいいことです。試用した後、我々の350-401試験復習赤本問題集はあなたを試験に順調に合格させると信じられます。なぜと言うのは、我々社の専門家は改革に応じて問題の更新と改善を続けていくのは出発点から勝つからです。

Cisco 350-401試験復習赤本 - それは受験者にとって重要な情報です。

我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。NewValidDumps Ciscoの350-401試験復習赤本試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。インターネットで時勢に遅れない350-401試験復習赤本勉強資料を提供するというサイトがあるかもしれませんが、NewValidDumpsはあなたに高品質かつ最新のCiscoの350-401試験復習赤本トレーニング資料を提供するユニークなサイトです。NewValidDumpsの勉強資料とCiscoの350-401試験復習赤本に関する指導を従えば、初めてCiscoの350-401試験復習赤本認定試験を受けるあなたでも一回で試験に合格することができます。

弊社の無料なサンプルを遠慮なくダウンロードしてください。君はまだCiscoの350-401試験復習赤本認証試験を通じての大きい難度が悩んでいますか？ 君はまだCisco 350-401試験復習赤本認証試験に合格するために寝食を忘れて頑張って復習しますか？ 早くてCisco 350-401試験復習赤本認証試験を通りたいですか？NewValidDumpsを選択しましょう！

350-401 PDF DEMO:

QUESTION NO: 1
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 2
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

VMware 5V0-43.21 - ためらわずに速くあなたのショッピングカートに入れてください。 NewValidDumpsを利用したら、CiscoのCompTIA 220-1102試験に合格するのを心配することはないです。 NewValidDumpsのCiscoのPRMIA 8011試験トレーニング資料はインターネットでの全てのトレーニング資料のリーダーです。 それに我々はいつもユーザーからのフィードバックを受け付け、アドバイスの一部をフルに活用していますから、完璧なNewValidDumpsのCiscoのSAP C-TS414-2021-JPN問題集を取得しました。 試験の準備をするためにNewValidDumpsのCiscoのHP HPE2-B03試験トレーニング資料を買うのは冒険的行為と思ったとしたら、あなたの人生の全てが冒険なことになります。

Updated: May 28, 2022