NewValidDumpsは君が最も早い時間でCiscoの350-401試験復習赤本試験に合格するのを助けます。私たちは君がITエリートになるのに頑張ります。NewValidDumpsは専門的で、たくさんの受験生のために、君だけのために存在するのです。 もし不合格になったら、私たちは全額返金することを保証します。一回だけでCiscoの350-401試験復習赤本試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。 NewValidDumpsを選ぶなら、絶対に後悔させません。

CCNP Enterprise 350-401 このサービスは無料なのです。

現在IT技術会社に通勤しているあなたは、Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)試験復習赤本試験認定を取得しましたか？350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)試験復習赤本試験認定は給料の増加とジョブのプロモーションに役立ちます。 今まで、弊社のNewValidDumpsの350-401 復習テキスト問題集はそのスローガンに沿って協力します。弊社の信頼できる350-401 復習テキスト問題集を使用したお客様はほとんど試験に合格しました。

だから、我々社は力の限りで弊社のCisco　350-401試験復習赤本試験資料を改善し、改革の変更に応じて更新します。あなたはいつまでも最新版の問題集を使用できるために、ご購入の一年間で無料の更新を提供します。人によって目標が違いますが、あなたにCisco　350-401試験復習赤本試験に順調に合格できるのは我々の共同の目標です。

Cisco 350-401試験復習赤本 - それも我々が全てのお客様に対する約束です。

NewValidDumpsの350-401試験復習赤本問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。もしこの問題集を利用してからやはり試験に不合格になってしまえば、NewValidDumpsは全額で返金することができます。あるいは、無料で試験350-401試験復習赤本問題集を更新してあげるのを選択することもできます。こんな保障がありますから、心配する必要は全然ないですよ。

実は良いトレーニング資料を選んだら試験に合格することは不可能ではないです。NewValidDumpsが提供したCiscoの350-401試験復習赤本「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料はあなたが試験に合格することを助けられます。

350-401 PDF DEMO:

QUESTION NO: 1
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 2
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

NewValidDumpsのITエリートたちは彼らの専門的な目で、最新的なCiscoのSAP C-THR97-2405試験トレーニング資料に注目していて、うちのCiscoのSAP C-THR97-2405問題集の高い正確性を保証するのです。 NewValidDumpsのCiscoのAmazon SAA-C03-JPN試験トレーニング資料は現在で一番人気があるダウンロードのフォーマットを提供します。 CiscoのAmazon SAA-C03-JPN認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。 Juniper JN0-335 - でも、成功へのショートカットがを見つけました。 購入した前の無料の試み、購入するときのお支払いへの保障、購入した一年間の無料更新CiscoのSAP C_TS4CO_2023-JPN試験に失敗した全額での返金…これらは我々のお客様への承諾です。

Updated: May 28, 2022