認証専門家や技術者及び全面的な言語天才がずっと最新のCiscoの350-401試験勉強書試験を研究していますから、Ciscoの350-401試験勉強書認定試験に受かりたかったら、NewValidDumpsのサイトをクッリクしてください。あなたに成功に近づいて、夢の楽園に一歩一歩進めさせられます。NewValidDumps Ciscoの350-401試験勉強書試験トレーニング資料というのは一体なんでしょうか。 NewValidDumpsというサイトのトレーニング資料を利用するかどうかがまだ決まっていなかったら、NewValidDumpsのウェブで一部の試験問題と解答を無料にダウンローしてみることができます。あなたに向いていることを確かめてから買うのも遅くないですよ。 試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。

CCNP Enterprise 350-401 そうすると、我々の信頼性をテストできます。

NewValidDumpsのITエリートたちは彼らの専門的な目で、最新的なCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)試験勉強書試験トレーニング資料に注目していて、うちのCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)試験勉強書問題集の高い正確性を保証するのです。 インターネットでこんな高品質の資料を提供するサイトはNewValidDumpsしかないです。NewValidDumpsのCiscoの350-401 過去問無料試験トレーニング資料はIT認証試験を受ける人々の必需品です。

Ciscoの350-401試験勉強書認定試験に合格することはきっと君の職業生涯の輝い将来に大変役に立ちます。NewValidDumpsを選ぶなら、君がCiscoの350-401試験勉強書認定試験に合格するということできっと喜んでいます。NewValidDumpsのCiscoの350-401試験勉強書問題集を購入するなら、君がCiscoの350-401試験勉強書認定試験に合格する率は１００パーセントです。

Cisco 350-401試験勉強書 - 早くNewValidDumpsの問題集を君の手に入れましょう。

NewValidDumpsのCiscoの350-401試験勉強書試験トレーニング資料を使ったら、君のCiscoの350-401試験勉強書認定試験に合格するという夢が叶えます。なぜなら、それはCiscoの350-401試験勉強書認定試験に関する必要なものを含まれるからです。NewValidDumpsを選んだら、あなたは簡単に認定試験に合格することができますし、あなたはITエリートたちの一人になることもできます。まだ何を待っていますか。早速買いに行きましょう。

もし弊社の商品が君にとっては何も役割にならなくて全額で返金いたいます。多くのIT者がCiscoの350-401試験勉強書認定試験を通してIT業界の中で良い就職機会を得たくて、生活水準も向上させたいです。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

NewValidDumpsのCiscoのMicrosoft AZ-700試験トレーニング資料はCiscoのMicrosoft AZ-700認定試験を準備するのリーダーです。 Peoplecert ITIL-4-Specialist-Monitor-Support-Fulfil - NewValidDumpsは認証試験の専門的なリーダーで、最全面的な認証基準のトレーニング方法を追求して、１００パーセントの成功率を保証します。 無料デモはあなたに安心で購入して、購入した後1年間の無料CiscoのGAQM CPST-001試験の更新はあなたに安心で試験を準備することができます、あなたは確実に購入を休ませることができます私たちのソフトウェアを試してみてください。 GIAC GMLE - 、弊社は最全面的な認証試験問題と解答を提供するだけでまく、一年間の無料更新サービスも提供いたします。 Fortinet NSE5_FMG-7.2-JPN - 我々の承諾だけでなく、お客様に最も全面的で最高のサービスを提供します。

Updated: May 28, 2022