試験を怖く感じるのはかなり正常です。特にCiscoの350-401無料試験のような難しい試験です。励ましだけであなたの試験への自信を高めるのは不可能だと知っていますから、我々は効果的なソフトを提供してあなたにCiscoの350-401無料試験試験に合格させます。 NewValidDumpsのCiscoの350-401無料試験トレーニング資料即ち問題と解答をダウンロードする限り、気楽に試験に受かることができるようになります。まだ困っていたら、我々の試用版を使ってみてください。 我々のウェブサイトであなたはCiscoの350-401無料試験試験のソフトを購入できます。

CCNP Enterprise 350-401 NewValidDumpsというサイトです。

CCNP Enterprise 350-401無料試験 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) 弊社の資料を使って、１００％に合格を保証いたします。 NewValidDumpsはあなたと苦楽を共にして、一緒に挑戦に直面します。あなたはIT職員ですか。

Cisco 350-401無料試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」認証試験に合格することが簡単ではなくて、Cisco 350-401無料試験証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。

Cisco 350-401無料試験 - では、どうしたらいいでしょうか。

夢を持ったら実現するために頑張ってください。「信仰は偉大な感情で、創造の力になれます。」とゴーリキーは述べました。私の夢は最高のIT専門家になることです。その夢は私にとってはるか遠いです。でも、成功へのショートカットがを見つけました。NewValidDumpsのCiscoの350-401無料試験試験トレーニング資料を利用して気楽に試験に合格しました。それはコストパフォーマンスが非常に高い資料ですから、もしあなたも私と同じIT夢を持っていたら、NewValidDumpsのCiscoの350-401無料試験試験トレーニング資料を利用してください。それはあなたが夢を実現することを助けられます。

はCiscoの350-401無料試験試験に合格するのに、私たちは最も早い時間で合格するのを追求します。

350-401 PDF DEMO:

QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

最近、CiscoのMicrosoft DP-203-KR試験は非常に人気のある認定試験です。 しかし、CiscoのPalo Alto Networks PSE-SWFW-Pro-24認定試験に合格するという夢は、NewValidDumpsに対して、絶対に掴められます。 IIA IIA-CIA-Part2 - あなたは試験の最新バージョンを提供することを要求することもできます。 競争がますます激しいIT業種では、CiscoのMicrosoft AI-102試験の認定は欠くことができない認証です。 Huawei H19-131_V1.0認定試験の資格を取得するのは容易ではないことは、すべてのIT職員がよくわかっています。

Updated: May 28, 2022