NewValidDumpsは多種なIT認証試験を受ける方を正確な資料を提供者でございます。弊社の無料なサンプルを遠慮なくダウンロードしてください。 IT職員のあなたは毎月毎月のあまり少ない給料を持っていますが、暇の時間でひたすら楽しむんでいいですか。Cisco　350-401模試エンジン試験認定書はIT職員野給料増加と仕事の昇進にとって、大切なものです。 君が選んだのはNewValidDumps、成功を選択したのに等しいです。

CCNP Enterprise 350-401 あなた準備しましたか。

真剣にNewValidDumpsのCisco 350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)模試エンジン問題集を勉強する限り、受験したい試験に楽に合格することができるということです。 あなたがする必要があるのは、問題集に出るすべての問題を真剣に勉強することです。この方法だけで、試験を受けるときに簡単に扱うことができます。

がむしゃらに試験に関連する知識を勉強しているのですか。それとも、効率が良い試験350-401模試エンジン参考書を使っているのですか。Ciscoの認証資格は最近ますます人気になっていますね。

Cisco 350-401模試エンジン - 早速買いに行きましょう。

350-401模試エンジン認定試験は現在で本当に人気がある試験ですね。まだこの試験の認定資格を取っていないあなたも試験を受ける予定があるのでしょうか。確かに、これは困難な試験です。しかし、難しいといっても、高い点数を取って楽に試験に合格できないというわけではないです。では、まだ試験に合格するショートカットがわからないあなたは、受験のテクニックを知りたいですか。今教えてあげますよ。それはNewValidDumpsの350-401模試エンジン問題集を利用することです。

NewValidDumpsのCiscoの350-401模試エンジン試験トレーニング資料はCiscoの350-401模試エンジン認定試験を準備するのリーダーです。NewValidDumpsの Ciscoの350-401模試エンジン試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。

350-401 PDF DEMO:

QUESTION NO: 1
Which description of an SD-Access wireless network infrastructure deployment is true?
A. The wireless client is part of the fabric overlay.
B. The access point is part of the fabric underlay.
C. The WLC is part of the fabric underlay.
D. The access point is part the fabric overlay.
Answer: B

QUESTION NO: 2
Which statement about a fabric access point is true?
A. It is in local mode an must connected directly to the fabric edge switch.
B. It is in FlexConnect mode and must be connected directly to the fabric edge switch.
C. It is in FlexConnect mode and must be connected directly to the fabric border node.
D. It is in local mode an must be connected directly to the fabric border node.
Answer: A
Explanation:
Fabric mode APs continue to support the same wireless media services that traditional APs support; apply AVC, quality of service (QoS), and other wireless policies; and establish the CAPWAP control plane to the fabric WLC. Fabric APs join as local-mode APs and must be directly connected to the fabric edge node switch to enable fabric registration events, including RLOC assignment via the fabric
WLC. The fabric edge nodes use CDP to recognize APs as special wired hosts, applying special port configurations and assigning the APs to a unique overlay network within a common EID space across a fabric. The assignment allows management simplification by using a single subnet to cover the AP infrastructure at a fabric site.
Reference: https://www.cisco.com/c/en/us/td/docs/solutions/CVD/Campus/sda-sdg-2019oct.html

QUESTION NO: 3
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 4
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

Microsoft AZ-305 - NewValidDumpsの学習教材はベストセラーになって、他のサイトをずっと先んじています。 無料デモはあなたに安心で購入して、購入した後1年間の無料CiscoのSAP C-C4HCX-2405試験の更新はあなたに安心で試験を準備することができます、あなたは確実に購入を休ませることができます私たちのソフトウェアを試してみてください。 SAP C_C4HCX_2405 - NewValidDumpsを選ぶなら、絶対に後悔させません。 H3C GB0-343 - 我々の承諾だけでなく、お客様に最も全面的で最高のサービスを提供します。 NewValidDumpsはCiscoのPegasystems PEGACPDS24V1試験トレーニング資料を提供する専門的なサイトです。

Updated: May 28, 2022