NewValidDumpsは実際の環境で本格的なCiscoの350-401日本語版対応参考書「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の試験の準備過程を提供しています。もしあなたは初心者若しくは専門的な技能を高めたかったら、NewValidDumpsのCiscoの350-401日本語版対応参考書「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の試験問題があなたが一歩一歩自分の念願に近くために助けを差し上げます。試験問題と解答に関する質問があるなら、当社は直後に解決方法を差し上げます。 万が一パースしない場合には、弊社は全額返金を承諾いたします。返金を願うのに対して、お客様は350-401日本語版対応参考書に合格しない成績書を弊社に送付して、弊社は確認の後、支払い金額を全部返済します。 我々は心からあなたが首尾よく試験に合格することを願っています。

CCNP Enterprise 350-401 私の夢は最高のIT専門家になることです。

短時間で一度に本当の認定試験に高いポイントを取得したいなら、我々NewValidDumpsのCisco　350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)日本語版対応参考書日本語対策問題集は絶対にあなたへの最善なオプションです。 さて、はやく試験を申し込みましょう。NewValidDumpsはあなたを助けることができますから、心配する必要がないですよ。

そうすれば、わかりやすく、覚えやすいです。弊社の 350-401日本語版対応参考書参考資料は実践に基づいて、専門的な知識の蓄積です。だから、350-401日本語版対応参考書試験のために、弊社の商品を選ばれば、後悔することがないです。

Cisco 350-401日本語版対応参考書 - もちろんありますよ。

Ciscoの350-401日本語版対応参考書の認証試験は現在IT業界でもっとも人気があって、その試験に合格すれば君の生活と仕事にいいです。 NewValidDumpsはCiscoの350-401日本語版対応参考書「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」の認証試験の合格率を高めるのウエブサイトで、NewValidDumps中のIT業界の専門家が研究を通じてCiscoの350-401日本語版対応参考書の認証試験について問題集を研究し続けています。100%合格率は彼らの研究成果でございます。NewValidDumpsを選られば、成功しましょう。

もしCiscoの350-401日本語版対応参考書問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。NewValidDumpsのCiscoの350-401日本語版対応参考書試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

CiscoのSAP C-S4CFI-2408認証試験に失敗したら弊社は全額で返金するのを保証いたします。 弊社のソフトを使用して、ほとんどのお客様は難しいと思われているCiscoのMicrosoft AZ-800試験に順調に剛角しました。 Microsoft AZ-104 - 合格書を持ち方が持たない人により高い給料をもうけられます。 我々のCiscoのGoogle Professional-Machine-Learning-Engineerソフトを利用してお客様の高通過率及び我々の技術の高いチームで、我々は自信を持って我々NewValidDumpsは専門的なのだと言えます。 Huawei H11-861_V3.0 - 模擬テスト問題集と真実の試験問題がよく似ています。

Updated: May 28, 2022