我々のCiscoの350-401最新テストソフトはあなたのすべての需要を満たすのを希望します。問題集の全面性と権威性、Ciscoの350-401最新テストソフトがPDF版、オンライン版とソフト版があるという資料のバーションの多様性、購入の前にデモの無料ダウンロード、購入の後でCiscoの350-401最新テストソフトの一年間の無料更新、これ全部は我々の誠の心を示しています。 NewValidDumpsの専門家チームが君の需要を満たすために自分の経験と知識を利用してCiscoの350-401最新テスト認定試験対策模擬テスト問題集が研究しました。模擬テスト問題集と真実の試験問題がよく似ています。 IT業界で就職する前に、あなたはCiscoの350-401最新テスト試験に合格したら、あなたに満足させる仕事を探す準備をよくしました。

CCNP Enterprise 350-401 君の初めての合格を目標にします。

NewValidDumpsのCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)最新テスト試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。 IT業界ではさらに強くなるために強い専門知識が必要です。多くの人々は高い難度のIT認証試験に合格するのは専門の知識が必要だと思います。

時間とお金の集まりより正しい方法がもっと大切です。Ciscoの350-401最新テスト試験のために勉強していますなら、NewValidDumpsの提供するCiscoの350-401最新テスト試験ソフトはあなたの選びの最高です。我々の目的はあなたにCiscoの350-401最新テスト試験に合格することだけです。

Cisco 350-401最新テスト - これは受験生の皆様を助けた結果です。

あなたは350-401最新テスト試験に不安を持っていますか？350-401最新テスト参考資料をご覧下さい。私たちの350-401最新テスト参考資料は十年以上にわたり、専門家が何度も練習して、作られました。あなたに高品質で、全面的な350-401最新テスト参考資料を提供することは私たちの責任です。私たちより、350-401最新テスト試験を知る人はいません。

Ciscoの350-401最新テスト試験に受かるのはあなたが自分をIT業種にアピールする方法の一つです。でも、試験に合格するために大量な時間とエネルギーを費やすことはなく、NewValidDumpsのCiscoの350-401最新テスト試験トレーニング資料を選んだらいいです。

350-401 PDF DEMO:

QUESTION NO: 1
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 2
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 5
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

VMware 2V0-41.24 - NewValidDumpsはきみの貴重な時間を節約するだけでなく、 安心で順調に試験に合格するのを保証します。 PMI PMO-CP - そうだったら、NewValidDumpsを利用したください。 Microsoft MS-700 - NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。 NewValidDumpsのCiscoのAmazon SAP-C02-JPN試験トレーニング資料はあなたの成功への第一歩です。 Microsoft MS-700-KR - そうしたらあなたはNewValidDumpsが用意した問題集にもっと自信があります。

Updated: May 28, 2022