NewValidDumpsを利用するのは君の合格率を１００％保証いたします。NewValidDumpsは多種なIT認証試験を受ける方を正確な資料を提供者でございます。弊社の無料なサンプルを遠慮なくダウンロードしてください。 350-401日本語版問題解説問題集のカーバー率が高いので、勉強した問題は試験に出ることが多いです。だから、弊社の提供する350-401日本語版問題解説問題集を暗記すれば、きっと試験に合格できます。 350-401日本語版問題解説認定試験の準備をするために、NewValidDumps の専門家たちは彼らの豊富な知識と実践を生かして特別なトレーニング資料を研究しました。

CCNP Enterprise 350-401 それがもう現代生活の不可欠な一部となりました。

Ciscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)日本語版問題解説認定試験に受かるのはあなたの技能を検証することだけでなく、あなたの専門知識を証明できて、上司は無駄にあなたを雇うことはしないことの証明書です。 試験に合格する秘密を見つけましたか。それを行う方法がわからない場合、私は教えてあげましょう。

あなたはキャリアで良い昇進のチャンスを持ちたいのなら、NewValidDumpsのCiscoの350-401日本語版問題解説「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」試験トレーニング資料を利用してCiscoの認証の証明書を取ることは良い方法です。現在、Ciscoの350-401日本語版問題解説認定試験に受かりたいIT専門人員がたくさんいます。NewValidDumpsの試験トレーニング資料はCiscoの350-401日本語版問題解説認定試験の１００パーセントの合格率を保証します。

Cisco 350-401日本語版問題解説 - おかげで試験に合格しました。

NewValidDumpsは優れたIT情報のソースを提供するサイトです。NewValidDumpsで、あなたの試験のためのテクニックと勉強資料を見つけることができます。NewValidDumpsのCiscoの350-401日本語版問題解説試験トレーニング資料は豊富な知識と経験を持っているIT専門家に研究された成果で、正確度がとても高いです。NewValidDumpsに会ったら、最高のトレーニング資料を見つけました。NewValidDumpsのCiscoの350-401日本語版問題解説試験トレーニング資料を持っていたら、試験に対する充分の準備がありますから、安心に利用したください。

NewValidDumpsのCiscoの350-401日本語版問題解説試験トレーニング資料はPDF形式とソフトウェアの形式で提供します。それはNewValidDumpsのCiscoの350-401日本語版問題解説試験の問題と解答を含まれます。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 3
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 4
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 5
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

NewValidDumpsのMicrosoft AZ-900-KR問題集の合格率が100%に達することも数え切れない受験生に証明された事実です。 君は他の人の一半の努力で、同じCiscoのIBM C1000-027認定試験を簡単に合格できます。 ASIS PSP - 試験を申し込みたいあなたは、いまどうやって試験に準備すべきなのかで悩んでいますか。 NewValidDumpsの CiscoのEsri EAPA_2025試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。 一回だけでCiscoのCompTIA N10-009J試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。

Updated: May 28, 2022