Ciscoの350-401復習過去問の認定試験に合格すれば、就職機会が多くなります。この試験に合格すれば君の専門知識がとても強いを証明し得ます。Ciscoの350-401復習過去問の認定試験は君の実力を考察するテストでございます。 NewValidDumpsはCiscoの350-401復習過去問認定試験にたいして短期で有効なウェブサイトで350-401復習過去問認定試験に合格するのを保証したり、Cisco認証試験に合格しなければ全額で返金いたします。あなたはNewValidDumpsが提供した350-401復習過去問の認証試験の問題集を購入するの前にインターネットで無料な試用版をダウンロードしてください。 きみはCiscoの350-401復習過去問認定テストに合格するためにたくさんのルートを選択肢があります。

CCNP Enterprise 350-401 きっと君に失望させないと信じています。

350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)復習過去問試験がユニバーサルになりましたから、あなたはNewValidDumps のCiscoの350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)復習過去問試験問題と解答￥を利用したらきっと試験に合格するができます。 我々は受験生の皆様により高いスピードを持っているかつ効率的なサービスを提供することにずっと力を尽くしていますから、あなたが貴重な時間を節約することに助けを差し上げます。NewValidDumps Ciscoの350-401 クラムメディア試験問題集はあなたに問題と解答に含まれている大量なテストガイドを提供しています。

これはさまざまな試験の実践の検査に合格したもので、Ciscoの350-401復習過去問認定試験に合格したかったら、NewValidDumpsを選ぶのは絶対正しいことです。Ciscoの350-401復習過去問認定試験に受かる勉強サイトを探しているのなら、NewValidDumpsはあなたにとって一番良い選択です。NewValidDumpsがあなたに差し上げられるのはIT業種の最先端のスキルを習得したこととCiscoの350-401復習過去問認定試験に合格したことです。

Cisco 350-401復習過去問 - あなた準備しましたか。

IT認定試験の中でどんな試験を受けても、NewValidDumpsの350-401復習過去問試験参考資料はあなたに大きなヘルプを与えることができます。それは NewValidDumpsの350-401復習過去問問題集には実際の試験に出題される可能性がある問題をすべて含んでいて、しかもあなたをよりよく問題を理解させるように詳しい解析を与えますから。真剣にNewValidDumpsのCisco 350-401復習過去問問題集を勉強する限り、受験したい試験に楽に合格することができるということです。

では、早くNewValidDumpsのサイトをクリックして問題集を購入しましょう。それに、購入する前に、資料のサンプルを試すことができます。

350-401 PDF DEMO:

QUESTION NO: 1
What is the difference between a RIB and a FIB?
A. The FIB is populated based on RIB content
B. The RIB is used to make IP source prefix-based switching decisions
C. The RIB maintains a mirror image of the FIB
D. The FIB is where all IP routing information is stored
Answer: A
Explanation:
CEF uses a Forwarding Information Base (FIB) to make IP destination prefix-based switching decisions.
The FIB is conceptually similar to a routing table or information base. It maintains a mirror image of the forwarding information contained in the IP routing table. When routing or topology changes occur in the network, the IP routing table is updated, and those changes are reflected in the FIB. The
FIB maintains next-hop address information based on the information in the IP routing table. Because there is a one-to-one correlation between FIB entries and routing table entries, the FIB contains all known routes and eliminates the need for route cache maintenance that is associated with earlier switching paths such as fast switching and optimum switching.
Note: In order to view the Routing information base (RIB) table, use the "show ip route" command.
To view the Forwarding Information Base (FIB), use the "show ip cef" command. RIB is in Control plane while FIB is in Data plane.

QUESTION NO: 2
Which feature does Cisco TrustSec use to provide scalable, secure communication throughout a network?
A. security group tag number assigned to each user on a switch
B. security group tag ACL assigned to each router on a network
C. security group tag ACL assigned to each port on a switch
D. security group tag number assigned to each port on a network
Answer: D
Explanation:
Cisco TrustSec uses tags to represent logical group privilege. This tag, called a Security Group Tag
(SGT), is used in access policies. The SGT is understood and is used to enforce traffic by Cisco switches, routers and firewalls . Cisco TrustSec is defined in three phases: classification, propagation and enforcement.
When users and devices connect to a network, the network assigns a specific security group.
This process is called classification. Classification can be based on the results of the authentication or by associating the SGT with an IP, VLAN, or port-profile (-> Answer A and answer C are not correct as they say "assigned ... on a switch" only. Answer D is not correct either as it says "assigned to each router").

QUESTION NO: 3
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 4
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

GIAC GMLE - がむしゃらに試験に関連する知識を勉強しているのですか。 Google Professional-Data-Engineer - どのように選択すべきなのかを知らないなら、私は教えてあげます。 AVIXA CTS-I - 早速買いに行きましょう。 PECB ISO-IEC-27001-Lead-Auditor-CN - では、まだ試験に合格するショートカットがわからないあなたは、受験のテクニックを知りたいですか。 SAP C-C4HCX-2405 - それは正確性が高くて、カバー率も広いです。

Updated: May 28, 2022