NewValidDumpsのCiscoの350-401復習時間試験トレーニング資料は最高のトレーニング資料です。IT職員としてのあなたは切迫感を感じましたか。NewValidDumpsを選んだら、成功への扉を開きます。 あなたは安心で我々の商品を購入できるために、我々は各バーションのCiscoの350-401復習時間復習資料のサンプルを提供してあなたに試させます。我々のCiscoの350-401復習時間復習資料を通して、いろいろな受験生はもうCiscoの350-401復習時間試験に合格しました。 そうすると、あなたがいつでも最新バージョンの資料を持っていることが保証されます。

CCNP Enterprise 350-401 できるだけ100％の通過率を保証使用にしています。

CCNP Enterprise 350-401復習時間 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) あなたにとても良い指導を確保できて、試験に合格するのを助けって、NewValidDumpsからすぐにあなたの通行証をとります。 ただ、社会に入るIT卒業生たちは自分能力の不足で、350-401 基礎問題集試験向けの仕事を探すのを悩んでいますか？それでは、弊社のCiscoの350-401 基礎問題集練習問題を選んで実用能力を速く高め、自分を充実させます。その結果、自信になる自己は面接のときに、面接官のいろいろな質問を気軽に回答できて、順調に350-401 基礎問題集向けの会社に入ります。

NewValidDumpsはきみのIT夢に向かって力になりますよ。Ciscoの350-401復習時間の認証そんなに人気があって、NewValidDumpsも君の試験に合格するために全力で助けてあげて、またあなたを一年の無料なサービスの更新を提供します。明日の成功のためにNewValidDumpsを選らばましょう。

Cisco 350-401復習時間 - 君の夢は1歩更に近くなります。

Ciscoの350-401復習時間の認定試験に合格すれば、就職機会が多くなります。この試験に合格すれば君の専門知識がとても強いを証明し得ます。Ciscoの350-401復習時間の認定試験は君の実力を考察するテストでございます。

心配することはないですよ、ヘルプがあなたの手元にありますから。NewValidDumpsを利用したら恐いことはないです。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

SAP C-IEE2E-2404 - あなたの全部な需要を満たすためにいつも頑張ります。 NewValidDumpsの勉強資料とCiscoのAmazon CLF-C02に関する指導を従えば、初めてCiscoのAmazon CLF-C02認定試験を受けるあなたでも一回で試験に合格することができます。 NewValidDumpsの専門家チームがCiscoのEsri EAPA_2025認証試験に対して最新の短期有効なトレーニングプログラムを研究しました。 製品検定合格の証明書あるいは他の人気がある身分検定によって、NewValidDumps CiscoのOracle 1Z0-902試験トレーニング資料の長所を完璧に見せることができます。 Microsoft MS-900-JPN - きっと君に失望させないと信じています。

Updated: May 28, 2022