それと比べるものがありません。専門的な団体と正確性の高いCiscoの350-401前提条件問題集があるこそ、NewValidDumpsのサイトは世界的で350-401前提条件試験トレーニングによっての試験合格率が一番高いです。NewValidDumpsを選んび、成功を選びます。 NewValidDumpsの試験トレーニング資料はCiscoの350-401前提条件認定試験の１００パーセントの合格率を保証します。近年、IT領域で競争がますます激しくなります。 君がうちの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

CCNP Enterprise 350-401 我々NewValidDumpsにあなたを助けさせてください。

あなたを試験に一発合格させる素晴らしい350-401 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)前提条件試験に関連する参考書が登場しますよ。 心配しないでください。私たちを見つけるのはあなたのCiscoの350-401 専門試験試験に合格する保障からです。

ここには、私たちは君の需要に応じます。NewValidDumpsのCiscoの350-401前提条件問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。もし不合格になったら、私たちは全額返金することを保証します。

Cisco 350-401前提条件 - 弊社の商品が好きなのは弊社のたのしいです。

あなたは弊社の商品を買ったら一年間に無料でアップサービスが提供された認定試験に合格するまで利用しても喜んでいます。もしテストの内容が変われば、すぐにお客様に伝えます。弊社はあなた１００％合格率を保証いたします。

NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。

350-401 PDF DEMO:

QUESTION NO: 1
What is the correct EBGP path attribute list, ordered from most preferred to the least preferred, that the BGP best-path algorithm uses?
A. weight, local preference, AS path, MED
B. weight, AS path, local preference, MED
C. local preference, weight MED, AS path
D. local preference, weight, AS path, MED
Answer: A
Explanation:
Path Selection Attributes: Weight > Local Preference > Originate > AS Path > Origin > MED > External
> IGP Cost > eBGP Peering > Router ID

QUESTION NO: 2
Which standard access control entry permits from odd-numbered hosts in the 10.0.0.0/24 subnet?
A. Permit 10.0.0.0.255.255.255.254
B. Permit 10.0.0.1.0.0.0.254
C. Permit 10.0.0.1.0.0.0.0
D. Permit 10.0.0.0.0.0.0.1
Answer: B
Explanation:
Remember, for the wildcard mask, 1's are I DON'T CARE, and 0's are I CARE. So now let's analyze a simple ACL:
access-list 1 permit 172.23.16.0 0.0.15.255
Two first octets are all 0's meaning that we care about the network 172.23.x.x. The third octet of the wildcard mask, 15 (0000 1111 in binary), means that we care about first 4 bits but don't care about last 4 bits so we allow the third octet in the form of 0001xxxx (minimum:00010000 = 16; maximum:
0001111 = 31).
The fourth octet is 255 (all 1 bits) that means I don't care.
Therefore network 172.23.16.0 0.0.15.255 ranges from 172.23.16.0 to 172.23.31.255.
Now let's consider the wildcard mask of 0.0.0.254 (four octet: 254 = 1111 1110) which means we only care the last bit. Therefore if the last bit of the IP address is a "1" (0000 0001) then only odd numbers are allowed. If the last bit of the IP address is a "0" (0000 0000) then only even numbers are allowed.
Note: In binary, odd numbers are always end with a "1" while even numbers are always end with a
"0".
Therefore in this question, only the statement "permit 10.0.0.1 0.0.0.254" will allow all odd- numbered hosts in the 10.0.0.0/24 subnet.

QUESTION NO: 3
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

QUESTION NO: 4
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 5
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

NewValidDumpsはCiscoのJuniper JN0-252認定試験「Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR)」に向けてもっともよい問題集を研究しています。 あなたはインターネットでCiscoのPMI PMO-CP認証試験の練習問題と解答の試用版を無料でダウンロードしてください。 Huawei H19-301_V3.0 - NewValidDumpsの問題集は最大のお得だね！ Huawei H19-301_V3.0 - NewValidDumpsはまた一年間に無料なサービスを更新いたします。 Microsoft MD-102-JPN - NewValidDumpsというサイトをクッリクしたらあなたの願いを果たせます。

Updated: May 28, 2022