もしあなたはCisco　350-401トレーニング資料試験に準備しているなら、あんたのための整理される備考資料はあなたにとって最善のオプションです。我々の目標はあなたに試験にうまく合格させることです。弊社の誠意を信じてもらいたいし、Cisco　350-401トレーニング資料試験2成功するのを祈って願います。 夢を持ったら実現するために頑張ってください。「信仰は偉大な感情で、創造の力になれます。 短時間で一度に本当の認定試験に高いポイントを取得したいなら、我々NewValidDumpsのCisco　350-401トレーニング資料日本語対策問題集は絶対にあなたへの最善なオプションです。

CCNP Enterprise 350-401 そうすれば、わかりやすく、覚えやすいです。

CCNP Enterprise 350-401トレーニング資料 - Implementing Cisco Enterprise Network Core Technologies (350-401 ENCOR) あなたは試験の最新バージョンを提供することを要求することもできます。 弊社の専門家は経験が豊富で、研究した問題集がもっとも真題と近づいて現場試験のうろたえることを避けます。Cisco 350-401 最速合格認証試験を通るために、いいツールが必要です。

350-401トレーニング資料認定試験の資格を取得するのは容易ではないことは、すべてのIT職員がよくわかっています。しかし、350-401トレーニング資料認定試験を受けて資格を得ることは自分の技能を高めてよりよく自分の価値を証明する良い方法ですから、選択しなければならならないです。ところで、受験生の皆さんを簡単にIT認定試験に合格させられる方法がないですか。

Cisco 350-401トレーニング資料 - これは本当に素晴らしいことです。

数年以来の整理と分析によって開発された350-401トレーニング資料問題集は権威的で全面的です。350-401トレーニング資料問題集を利用して試験に合格できます。この問題集の合格率は高いので、多くのお客様から350-401トレーニング資料問題集への好評をもらいました。350-401トレーニング資料問題集のカーバー率が高いので、勉強した問題は試験に出ることが多いです。だから、弊社の提供する350-401トレーニング資料問題集を暗記すれば、きっと試験に合格できます。

あなたは一回で気楽に試験に合格することを保証します。将来で新しいチャンスを作って、仕事が楽しげにやらせます。

350-401 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit. A port channel is configured between SW2 and SW3. SW2 is not running a
Cisco operating system. When all physical connections are mode, the port channel does not establish.
Based on the configuration excerpt of SW3, what is the cause of the problem?
A. The port-channel interface lead balance should be set to src-mac
B. The port-channel trunk is not allowing the native VLAN.
C. The port-channel should be set to auto.
D. The port channel on SW2 is using an incompatible protocol.
Answer: D
Explanation:
The Cisco switch was configured with PAgP, which is a Cisco proprietary protocol so non-Cisco switch could not communicate.

QUESTION NO: 2
Which technology provides a secure communication channel for all traffic at Layer 2 of the OSI model?
A. IPsec
B. Cisco Trustsec
C. MACsec
D. SSL
Answer: C
Explanation:
MACsec, defined in 802.1AE, provides MAC-layer encryption over wired networks by using out- of
-band methods for encryption keying. The MACsec Key Agreement (MKA) Protocol provides the required session keys and manages the required encryption keys. MKA and MACsec are implemented after successful authentication using the 802.1x Extensible Authentication Protocol (EAP-TLS) or Pre
Shared Key (PSK) framework.
A switch using MACsec accepts either MACsec or non-MACsec frames, depending on the policy associated with the MKA peer. MACsec frames are encrypted and protected with an integrity check value (ICV). When the switch receives frames from the MKA peer, it decrypts them and calculates the correct ICV by using session keys provided by MKA. The switch compares that ICV to the ICV within the frame. If they are not identical, the frame is dropped. The switch also encrypts and adds an ICV to any frames sent over the secured port (the access point used to provide the secure MAC service to a
MKA peer) using the current session key.
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-
9/configuration_guide/sec/b_169_sec_9300_cg/macsec_encryption.html
Note: Cisco Trustsec is the solution which includes MACsec.

QUESTION NO: 3
Which statement about multicast RPs is true?
A. RPs are required for protocol independent multicast sparse mode and dense mode.
B. By default, the RP is needed only to start new sessions with sources and receivers.
C. By default, the RP is needed periodically to maintain sessions with sources and receivers
D. RPs are required only when using protocol independent multicast dense mode.
Answer: B
Explanation:
A rendezvous point (RP) is required only in networks running Protocol Independent Multicast sparse mode (PIM-SM).
By default, the RP is needed only to start new sessions with sources and receivers.
Reference:
https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html
For your information, in PIM-SM, only network segments with active receivers that have explicitly requested multicast data will be forwarded the traffic. This method of delivering multicast data is in contrast to the PIM dense mode (PIM-DM) model. In PIM-DM, multicast traffic is initially flooded to all segments of the network. Routers that have no downstream neighbors or directly connected receivers prune back the unwanted traffic.

QUESTION NO: 4
To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller.
Which EtherChannel mode must be configured on the switch to allow the WLC to connect?
A. Active
B. On
C. Auto
D. Passive
Answer: B
Explanation:
Restrictions for Link Aggregation:
You can bundle all eight ports on a Cisco 5508 Controller into a single link.
Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails. The controller's port 1 is connected to Gigabit interface 3/1, and the controller's port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. Both switch ports are assigned to the same channel group.
LAG requires the EtherChannel to be configured for 'mode on' on both the controller and the Catalyst switch.
Once the EtherChannel is configured as on at both ends of the link, the Catalyst switch should not be configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation
Protocol (PAgP) but be set unconditionally to LAG. Because no channel negotiation is done between the controller and the switch, the controller does not answer to negotiation frames and the LAG is not formed if a dynamic form of LAG is set on the switch. Additionally, LACP and PAgP are not supported on the controller.
If the recommended load-balancing method cannot be configured on the Catalyst switch, then configure the LAG connection as a single member link or disable LAG on the controller.
https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-5/configuration- guide/b_cg75/b_cg75_chapter_0100010.html

QUESTION NO: 5
Which access controls list allows only TCP traffic with a destination port range of 22-433, excluding port 80?
A. Deny tcp any any ne 80
Permit tcp any any range 22 443
B. Permit tcp any any ne 80
C. Permit tco any any range 22 443
Deny tcp any any eq 80
D. Deny tcp any any eq 80
Permit tco any any gt 21 it 444
Answer: D

Microsoft PL-300J - NewValidDumpsにたくさんのIT専門人士がいって、弊社の問題集に社会のITエリートが認定されて、弊社の問題集は試験の大幅カーバして、合格率が１００％にまで達します。 NewValidDumpsのCiscoのThe Open Group OG0-093試験トレーニング資料は成功したいIT職員のために作成されたのです。 CiscoのSAP C-C4H63-2411試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でNewValidDumpsは君の試験の問題を準備してしまいました。 NewValidDumpsのCiscoのAmazon SAA-C03試験トレーニング資料の値段は手頃で、IT認証の受験生のみなさんによく適用します。 Microsoft PL-900 - NewValidDumpsはあなたの夢に実現させるサイトでございます。

Updated: May 28, 2022