Network ApplianceのNS0-180真実試験試験に合格することは容易なことではなくて、良い訓練ツールは成功の保証でNewValidDumpsは君の試験の問題を準備してしまいました。君の初めての合格を目標にします。 あなたがNetwork ApplianceのNS0-180真実試験認定試験に合格するのに最も良くて、最も必要な学習教材です。うちのNetwork ApplianceのNS0-180真実試験問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。 どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。

NCSIE NS0-180 もし弊社の問題集を勉強してそれは簡単になります。

我々の目的はあなたにNetwork ApplianceのNS0-180 - NetApp Certified Storage Installation Engineer, Clustered Data ONTAP真実試験試験に合格することだけです。 弊社の資料を使って、１００％に合格を保証いたします。NewValidDumpsはIT試験問題集を提供するウエブダイトで、ここによく分かります。

自分のIT業界での発展を希望したら、Network ApplianceのNS0-180真実試験試験に合格する必要があります。Network ApplianceのNS0-180真実試験試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはNetwork ApplianceのNS0-180真実試験試験に合格することができます。Network ApplianceのNS0-180真実試験試験を準備しているあなたに試験に合格させるために、我々NewValidDumpsは模擬試験ソフトを更新し続けています。

Network Appliance NS0-180真実試験 - しかも、一年間の無料更新サービスを提供します。

あなたはNS0-180真実試験試験に不安を持っていますか？NS0-180真実試験参考資料をご覧下さい。私たちのNS0-180真実試験参考資料は十年以上にわたり、専門家が何度も練習して、作られました。あなたに高品質で、全面的なNS0-180真実試験参考資料を提供することは私たちの責任です。私たちより、NS0-180真実試験試験を知る人はいません。

NewValidDumps のNS0-180真実試験試験トレーニング資料は特別にデザインしてできるだけあなたの仕事の効率を改善するのソフトです。NewValidDumpsは世界的にこの試験の合格率を最大限に高めることに力を尽くしています。

NS0-180 PDF DEMO:

QUESTION NO: 1
Click the Exhibit button.
You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)
A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.
Answer: B,C
Explanation:
After you cable the SAS connections, you have the option to cable the Alternative Control Path (ACP) connections. You should use the ACP protocol because it enables Data ONTAP to manage and control the SAS disk shelf storage subsystem

QUESTION NO: 2
A customer learns that a certain NetApp tool allows remote data collection, intelligent core file handling, and notification of down storage controllers for technical support analysis and troubleshooting.
What is the name of this tool?
A. RSA
B. HWU
C. Synergy
D. HW Assist
Answer: A
Explanation:
Remote Support Agent (RSA) is a remote diagnostics data collector that is embedded directly into the storage controller's remote management device firmware. Remote Support Agent enables a NetApp support engineer to remotely request an automated upload of log files, core files, and other diagnostic information stored in the storage controller and to remotely trigger an on-demand
AutoSupport collection. Incorrect: Not B: The Hardware Universe (HWU) application is NetApp's system configuration solution. Not C: NetApp Synergy is a complete design, deployment and documentation tool. The program enables you to build a very accurate, detailed model of a NetApp storage system. You can represent most aspects of a storage deployment including the hardware configuration and the sizing of all storage containers, including aggregates, volumes, qtrees and
LUNs.
Reference: Clustered Data ONTAP 8.2, Remote Support Agent Configuration Guide, Page 5

QUESTION NO: 3
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
A. Cisco Catalyst 2960
B. Cisco NX5596
C. NetApp CN1610
D. NetApp CN1601
Answer: B,C
Explanation:
Cisco NX5596 is a cluster interconnect switch. NetApp CN1610 is a cluster interconnect switch that can be used for FAS8040 nodes.
Incorrect:
Not A: The Cisco Catalyst 2960 is not a cluster interconnect switch. Not D: NetApp CN1601 is a cluster management switch.
Reference: Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems

QUESTION NO: 4
Advanced Drive Partitioning (ADP) is available for which three NetApp systems? (Choose three.)
A. FAS80XX with SAS and SATA disks
B. FAS25XX with SSD disks
C. FAS80XX with SATA disks
D. FAS25XX with SATA disks
E. FAS80XX with SSD disks
Answer: B,D,E
Explanation:
ADP supported platforms: B, D: 2200, 2500 (Internal drives): Root Data Slice (HDD), Root Data Slice
(AFF - All Flash FAS)
E: 3200, 6200, 8000 ( 48 drives) : Root Data Slice (AFF - All Flash FAS) Example ADP configuration: FAS8040 All-Flash (36 x 800GB SSD)
Reference: NETAPP DATAONTAP 8.3 | ADP ROOT DISK-SLICE DEEP-DIVE
http://www.datacenterdan.com/blog/netapp-dataontap-83-adp-root-disk-slice-deep-dive

QUESTION NO: 5
You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?
A. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.
B. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.
C. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.
D. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.
Answer: B
Explanation:
One possibly cause is Disk I/O contention on the data volume. The root volume in Cluster-Mode is used to store and update various tables of the replicated database. Crucial information regarding the locations of LIFs, volumes, aggregates, and different jobs required to run in the cluster are stored in these tables. If a root aggregate has very busy data volumes, the disks in the aggregate will experience higher latency. When a node is unable to update its copy of the replicated database fast enough, it will consider itself unhealthy and stop serving all the data until it can catch up. This is extremely disruptive and affects all the volumes on the node, even if the cause is related to the data volumes stored on the root aggregate only.
Reference:
Why is a warning displayed when attempting to create one or more data volumes in the root aggregate in Data ONTAP Cluster-Mode?
https://kb.netapp.com/support/index?id=3013563&page=content&locale=en_US

CompTIA FC0-U61 - 弊社の商品が好きなのは弊社のたのしいです。 NewValidDumps Network ApplianceのPECB ISO-IEC-27001-Lead-Auditor試験材料は最も実用的なIT認定材料を提供することを確認することができます。 Microsoft SC-300J - NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。 心配することはないよ、NewValidDumpsのNetwork ApplianceのMicrosoft SC-100J試験トレーニング資料がありますから。 あなたはインターネットでNetwork ApplianceのOracle 1z1-071-JPN認証試験の練習問題と解答の試用版を無料でダウンロードしてください。

Updated: May 28, 2022