NewValidDumpsは長年にわたってずっとIT認定試験に関連するNS0-180受験資格参考書を提供しています。これは受験生の皆さんに検証されたウェブサイトで、一番優秀な試験NS0-180受験資格問題集を提供することができます。NewValidDumpsは全面的に受験生の利益を保証します。 がむしゃらに試験に関連する知識を勉強しているのですか。それとも、効率が良い試験NS0-180受験資格参考書を使っているのですか。 うちのNetwork ApplianceのNS0-180受験資格試験問題集は完全な無制限のダンプが含まれているから、使ったら気楽に試験に合格することができます。

NCSIE NS0-180 まだ何を待っていますか。

うちのNetwork ApplianceのNS0-180 - NetApp Certified Storage Installation Engineer, Clustered Data ONTAP受験資格試験トレーニング資料は豊富な経験を持っている専門家が長年の研究を通じて開発されたものです。 それは正確性が高くて、カバー率も広いです。あなたはNewValidDumpsの学習教材を購入した後、私たちは一年間で無料更新サービスを提供することができます。

信じられないなら、弊社のデモをやってみて、Network ApplianceのNS0-180受験資格試験問題集を体験することができます。試して我々専門家たちの真面目さを感じられています。Network ApplianceのNS0-180受験資格試験のほかの試験に参加するつもりでしたら、あなたも弊社のNewValidDumpsでふさわしいソフトを探すことができます。

Network ApplianceのNetwork Appliance NS0-180受験資格試験の準備は重要です。

社会と経済の発展につれて、多くの人はIT技術を勉強します。なぜならば、IT職員にとって、Network ApplianceのNS0-180受験資格資格証明書があるのは肝心な指標であると言えます。自分の能力を証明するために、NS0-180受験資格試験に合格するのは不可欠なことです。弊社のNS0-180受験資格真題を入手して、試験に合格する可能性が大きくなります。

ほかの人はあちこちNetwork ApplianceのNS0-180受験資格試験の資料を探しているとき、あなたは問題集の勉強を始めました。準備の段階であなたはリーダーしています。

NS0-180 PDF DEMO:

QUESTION NO: 1
Click the Exhibit button.
You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)
A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.
Answer: B,C
Explanation:
After you cable the SAS connections, you have the option to cable the Alternative Control Path (ACP) connections. You should use the ACP protocol because it enables Data ONTAP to manage and control the SAS disk shelf storage subsystem

QUESTION NO: 2
A customer learns that a certain NetApp tool allows remote data collection, intelligent core file handling, and notification of down storage controllers for technical support analysis and troubleshooting.
What is the name of this tool?
A. RSA
B. HWU
C. Synergy
D. HW Assist
Answer: A
Explanation:
Remote Support Agent (RSA) is a remote diagnostics data collector that is embedded directly into the storage controller's remote management device firmware. Remote Support Agent enables a NetApp support engineer to remotely request an automated upload of log files, core files, and other diagnostic information stored in the storage controller and to remotely trigger an on-demand
AutoSupport collection. Incorrect: Not B: The Hardware Universe (HWU) application is NetApp's system configuration solution. Not C: NetApp Synergy is a complete design, deployment and documentation tool. The program enables you to build a very accurate, detailed model of a NetApp storage system. You can represent most aspects of a storage deployment including the hardware configuration and the sizing of all storage containers, including aggregates, volumes, qtrees and
LUNs.
Reference: Clustered Data ONTAP 8.2, Remote Support Agent Configuration Guide, Page 5

QUESTION NO: 3
Advanced Drive Partitioning (ADP) is available for which three NetApp systems? (Choose three.)
A. FAS80XX with SAS and SATA disks
B. FAS25XX with SSD disks
C. FAS80XX with SATA disks
D. FAS25XX with SATA disks
E. FAS80XX with SSD disks
Answer: B,D,E
Explanation:
ADP supported platforms: B, D: 2200, 2500 (Internal drives): Root Data Slice (HDD), Root Data Slice
(AFF - All Flash FAS)
E: 3200, 6200, 8000 ( 48 drives) : Root Data Slice (AFF - All Flash FAS) Example ADP configuration: FAS8040 All-Flash (36 x 800GB SSD)
Reference: NETAPP DATAONTAP 8.3 | ADP ROOT DISK-SLICE DEEP-DIVE
http://www.datacenterdan.com/blog/netapp-dataontap-83-adp-root-disk-slice-deep-dive

QUESTION NO: 4
What are two supported cluster interconnect switches for the FAS8040 nodes? (Choose two.)
A. Cisco Catalyst 2960
B. Cisco NX5596
C. NetApp CN1610
D. NetApp CN1601
Answer: B,C
Explanation:
Cisco NX5596 is a cluster interconnect switch. NetApp CN1610 is a cluster interconnect switch that can be used for FAS8040 nodes.
Incorrect:
Not A: The Cisco Catalyst 2960 is not a cluster interconnect switch. Not D: NetApp CN1601 is a cluster management switch.
Reference: Clustered Data ONTAP 8.3, Express Setup Guide for 80xx Systems

QUESTION NO: 5
You want to create a data volume on aggr0 and you receive a message with the following warning:
''Warning: You are about to create a volume on a root aggregate. This may cause severe performance or stability problems and therefore is not recommended. Do you want to proceed?''
What is the reason for this severe performance or stability problem?
A. Controller failover and storage failover are separate processes that must occur in parallel, otherwise problems will arise.
B. The performance load generated by the data volume can be very strong, so it should not be shared with vol0 on aggr0, requiring a separate aggregate for it.
C. The performance load generated by the vol0 cannot be shared with any other volume on aggr0, requiring a dedicated aggregate for it.
D. Controller failover and storage failover are separate processes that must occur at different times, otherwise problems will arise.
Answer: B
Explanation:
One possibly cause is Disk I/O contention on the data volume. The root volume in Cluster-Mode is used to store and update various tables of the replicated database. Crucial information regarding the locations of LIFs, volumes, aggregates, and different jobs required to run in the cluster are stored in these tables. If a root aggregate has very busy data volumes, the disks in the aggregate will experience higher latency. When a node is unable to update its copy of the replicated database fast enough, it will consider itself unhealthy and stop serving all the data until it can catch up. This is extremely disruptive and affects all the volumes on the node, even if the cause is related to the data volumes stored on the root aggregate only.
Reference:
Why is a warning displayed when attempting to create one or more data volumes in the root aggregate in Data ONTAP Cluster-Mode?
https://kb.netapp.com/support/index?id=3013563&page=content&locale=en_US

あなたにNetwork Appliance　SAP E_S4CPE_2023試験に関する最新かつ最完備の資料を勉強させ、試験に合格させることだと信じます。 我が社のHuawei H13-313_V1.0問題集は必ずあなたの成功へ道の助力になれます。 周りの多くの人は全部Network Appliance　Juniper JN0-280資格認定試験にパースしまして、彼らはどのようにできましたか。 我々の問題集によって、ほとんどの受験生は大方の人から見る大変なNetwork Appliance　Microsoft PL-200試験にうまく合格しました。 そうすれば、あなたは簡単にIBM C1000-168復習教材のデモを無料でダウンロードできます。

Updated: May 28, 2022