もしあなたが初心者だったら、または自分の知識や専門的なスキルを高めたいのなら、NewValidDumpsのCiscoの642-997過去問無料問題集があなたを助けることができ、一歩一歩でその念願を実現することにヘルプを差し上げます。NewValidDumpsのCiscoの642-997過去問無料は試験に関する全ての質問が解決して差し上げられます。それに一年間の無料更新サービスを提供しますから、NewValidDumpsのウェブサイトをご覧ください。 NewValidDumpsのウェブサイトに行ってもっとたくさんの情報をブラウズして、あなたがほしい試験642-997過去問無料参考書を見つけてください。642-997過去問無料認定試験の資格を取得するのは容易ではないことは、すべてのIT職員がよくわかっています。 NewValidDumpsというサイトは世界的に知名度が高いです。

CCNP Data Center 642-997 」と思わないでください。

CCNP Data Center 642-997過去問無料 - Implementing Cisco Data Center Unified Fabric (DCUFI) 試験に失敗したら、全額で返金する承諾があります。 それはより良く自分自身を向上させることができますから。もっと大切なのは、あなたもより多くの仕事のスキルをマスターしたことを証明することができます。

我々の提供するPDF版のCiscoの642-997過去問無料試験の資料はあなたにいつでもどこでも読めさせます。我々もオンライン版とソフト版を提供します。すべては豊富な内容があって各自のメリットを持っています。

Cisco 642-997過去問無料 - どんなツールが最高なのかを知りたいですか。

我々NewValidDumpsはCiscoの642-997過去問無料試験問題集をリリースする以降、多くのお客様の好評を博したのは弊社にとって、大変な名誉なことです。また、我々はさらに認可を受けられるために、皆様の一切の要求を満足できて喜ぶ気持ちでずっと協力し、完備かつ精確の642-997過去問無料試験問題集を開発するのに準備します。

はやくNewValidDumpsの642-997過去問無料問題集を入手しましょう。この問題集を持っていたら、どうやって効率的に試験の準備をすべきなのかをよく知るようになります。

642-997 PDF DEMO:

QUESTION NO: 1
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 2
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 3
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 4
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 5
Which management feature provides these functions?
* Direct paging of network support engineers
* Email notifications to a network operations center
* Direct Service Request generation with the Cisco TAC
A. scripting along with the scheduler feature
B. RSA
C. Call Home
D. SNMP traps
Answer: C

たとえば、ベストセラーのCisco　CheckPoint 156-315.81.20問題集は過去のデータを分析して作成ます。 NewValidDumpsのCiscoのNutanix NCS-Coreの試験問題と解答は当面の市場で最も徹底的な正確的な最新的な模擬テストです。 この問題集の合格率は高いので、多くのお客様からLpi 300-300問題集への好評をもらいました。 君がCiscoのLinux Foundation FOCP問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。 Juniper JN0-664 - NewValidDumpsは同業の中でそんなに良い地位を取るの原因は弊社のかなり正確な試験の練習問題と解答そえに迅速の更新で、このようにとても良い成績がとられています。

Updated: May 28, 2022