君はまだCisco 642-997資格専門知識認証試験を通じての大きい難度が悩んでいますか？ 君はまだCisco 642-997資格専門知識認証試験に合格するために寝食を忘れて頑張って復習しますか？ 早くてCisco 642-997資格専門知識認証試験を通りたいですか？NewValidDumpsを選択しましょう！NewValidDumpsはきみのIT夢に向かって力になりますよ。 世の中に去年の自分より今年の自分が優れていないのは立派な恥です。それで、IT人材として毎日自分を充実して、642-997資格専門知識問題集を学ぶ必要があります。 だからいろいろな方は試験を借って、自分の社会の地位を固めたいです。

CCNP Data Center 642-997 NewValidDumpsは君のもっともよい選択ですよ。

CCNP Data Center 642-997資格専門知識 - Implementing Cisco Data Center Unified Fabric (DCUFI) 弊社の商品が好きなのは弊社のたのしいです。 NewValidDumpsを選択したら、成功が遠くではありません。NewValidDumpsが提供するCiscoの642-997 模擬トレーリング認証試験問題集が君の試験に合格させます。

NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。

Cisco 642-997資格専門知識 - あなたに予想外の良い効果を見せられますから。

あなたはインターネットでCiscoの642-997資格専門知識認証試験の練習問題と解答の試用版を無料でダウンロードしてください。そうしたらあなたはNewValidDumpsが用意した問題集にもっと自信があります。早くNewValidDumpsの問題集を君の手に入れましょう。

NewValidDumps は各受験生のニーズを知っていて、あなたが642-997資格専門知識認定試験に受かることに有効なヘルプを差し上げます。あなたが首尾よく試験に合格するように、我々は最も有利な価格と最高のクオリティーを提供して差し上げます。

642-997 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 2
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 3
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 4
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 5
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

SAP C_S43_2022 - NewValidDumpsはまた一年間に無料なサービスを更新いたします。 NewValidDumpsのCiscoのPMI PMP-CN試験トレーニング資料はあなたが完全に問題と問題に含まれているコンセプトを理解できることを保証しますから、あなたは気楽に一回で試験に合格することができます。 弊社のScrum SPSのトレーニング資料を買ったら、一年間の無料更新サービスを差し上げます。 Amazon SOA-C02-JPN - あなたが自分のキャリアでの異なる条件で自身の利点を発揮することを助けられます。 認証専門家や技術者及び全面的な言語天才がずっと最新のCiscoのEXIN PR2F試験を研究していますから、CiscoのEXIN PR2F認定試験に受かりたかったら、NewValidDumpsのサイトをクッリクしてください。

Updated: May 28, 2022