初心者にとって、642-997試験勉強攻略試験に合格するのはそんなに難しいことですか？実は、我々NewValidDumpsの642-997試験勉強攻略問題集を選んで利用し、お客様は力の限りまで勉強して、合格しやすいです。万が一パースしない場合には、弊社は全額返金を承諾いたします。返金を願うのに対して、お客様は642-997試験勉強攻略に合格しない成績書を弊社に送付して、弊社は確認の後、支払い金額を全部返済します。 NewValidDumpsのCiscoの642-997試験勉強攻略試験問題資料は質が良くて値段が安い製品です。我々は低い価格と高品質の模擬問題で受験生の皆様に捧げています。 我々社NewValidDumpsは試験政策の変化に応じて、Ciscoの642-997試験勉強攻略問題集をタイムリーに更新しています。

CCNP Data Center 642-997 「信仰は偉大な感情で、創造の力になれます。

このいいチャンスを把握して、NewValidDumpsの642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)試験勉強攻略試験問題集の無料デモをダウンロードして勉強しましょう。 最近、Ciscoの642-997 コンポーネント試験は非常に人気のある認定試験です。あなたもこの試験の認定資格を取得したいのですか。

642-997試験勉強攻略参考資料は多くの人の絶対いい選択です。642-997試験勉強攻略参考資料の難点については、弊社の専門家ガ例を挙げて説明します。そうすれば、わかりやすく、覚えやすいです。

Cisco 642-997試験勉強攻略 - NewValidDumpsを選られば、成功しましょう。

NewValidDumpsのCiscoの642-997試験勉強攻略試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。君がCiscoの642-997試験勉強攻略問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの642-997試験勉強攻略問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。

君はまずネットで無料な部分のCisco認証試験をダウンロードして現場の試験の雰囲気を感じて試験に上手になりますよ。Ciscoの642-997試験勉強攻略認証試験に失敗したら弊社は全額で返金するのを保証いたします。

642-997 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 2
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 3
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 4
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 5
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

ISTQB CTAL-TTA - すべてのことの目的はあなたに安心に試験に準備さされるということです。 Microsoft SC-900J - 合格書を持ち方が持たない人により高い給料をもうけられます。 Citrix 1Y0-204J - 試験に失敗したら、全額で返金する承諾があります。 Palo Alto Networks PCNSA-JPN - 一目でわかる最新の出題傾向でわかりやすい解説と充実の補充問題があります。 SAP C_C4H320_34 - すべては豊富な内容があって各自のメリットを持っています。

Updated: May 28, 2022