人生は自転車に乗ると似ていて、やめない限り、倒れないから。IT技術職員として、周りの人はCisco　642-997独学書籍試験に合格し高い月給を持って、上司からご格別の愛護を賜り更なるジョブプロモーションを期待されますけど、あんたはこういうように所有したいますか。変化を期待したいあなたにCisco　642-997独学書籍試験備考資料を提供する権威性のあるNewValidDumpsをお勧めさせていただけませんか。 Ciscoの642-997独学書籍試験トレーニングソースを提供するサイトがたくさんありますが、NewValidDumpsは最実用な資料を提供します。NewValidDumpsには専門的なエリート団体があります。 642-997独学書籍試験参考書の内容は全面的で、わかりやすいです。

CCNP Data Center 642-997 NewValidDumpsを選んだら、成功への扉を開きます。

CCNP Data Center 642-997独学書籍 - Implementing Cisco Data Center Unified Fabric (DCUFI) NewValidDumpsはまた一年間に無料なサービスを更新いたします。 それに、NewValidDumpsの教材を購入すれば、NewValidDumpsは一年間の無料アップデート・サービスを提供してあげます。問題が更新される限り、NewValidDumpsは直ちに最新版の642-997 テスト難易度資料を送ってあげます。

NewValidDumpsは受験者に向かって試験について問題を解決する受験資源を提供するサービスのサイトで、さまざまな受験生によって別のトレーニングコースを提供いたします。受験者はNewValidDumpsを通って順調に試験に合格する人がとても多くなのでNewValidDumpsがIT業界の中で高い名声を得ました。

Cisco 642-997独学書籍 - 常々、時間とお金ばかり効果がないです。

NewValidDumps のCiscoの642-997独学書籍問題集はシラバスに従って、それに642-997独学書籍認定試験の実際に従って、あなたがもっとも短い時間で最高かつ最新の情報をもらえるように、弊社はトレーニング資料を常にアップグレードしています。弊社の642-997独学書籍のトレーニング資料を買ったら、一年間の無料更新サービスを差し上げます。もっと長い時間をもらって試験を準備したいのなら、あなたがいつでもサブスクリプションの期間を伸びることができます。

試験が更新されているうちに、我々はCiscoの642-997独学書籍試験の資料を更新し続けています。できるだけ100％の通過率を保証使用にしています。

642-997 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 2
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 3
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 4
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 5
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

Splunk SPLK-3002 - それはあなたが成功認定を助ける良いヘルパーですから、あなたはまだ何を待っているのですか。 Microsoft AI-900J - 自分の幸せは自分で作るものだと思われます。 NewValidDumps が提供したCiscoのSalesforce Marketing-Cloud-Account-Engagement-Specialist問題集は実践の検査に合格したもので、最も良い品質であなたがCiscoのSalesforce Marketing-Cloud-Account-Engagement-Specialist認定試験に合格することを保証します。 あなたは弊社の高品質Cisco　Fortinet NSE7_PBC-7.2試験資料を利用して、一回に試験に合格します。 NewValidDumpsはCiscoのPegasystems PEGACPSSA23V1試験トレーニング資料を提供できます。

Updated: May 28, 2022