今は時間がそんなに重要な社会でもっとも少ないお時間を使って試験に合格するのは一番よいだと思います。NewValidDumpsが短期な訓練を提供し、一回に君の試験に合格させることができます。試験に失敗したら、全額で返金いたします。 NewValidDumpsはあなたの夢に実現させるサイトでございます。どんな業界で自分に良い昇進機会があると希望する職人がとても多いと思って、IT業界にも例外ではありません。 NewValidDumpsにIT業界のエリートのグループがあって、彼達は自分の経験と専門知識を使ってCisco 642-997絶対合格認証試験に参加する方に対して問題集を研究続けています。

CCNP Data Center 642-997 近年、IT領域で競争がますます激しくなります。

Ciscoの642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)絶対合格認定試験に関する研究資料が重要な一部です。 NewValidDumpsのCiscoの642-997 問題無料試験トレーニング資料は豊富な知識と経験を持っているIT専門家に研究された成果で、正確度がとても高いです。NewValidDumpsに会ったら、最高のトレーニング資料を見つけました。

それもほとんどの受験生はNewValidDumpsを選んだ理由です。NewValidDumpsはいつまでも受験生のニーズに注目していて、できるだけ皆様のニーズを満たします。NewValidDumpsのCiscoの642-997絶対合格試験トレーニング資料は今までがないIT認証のトレーニング資料ですから、NewValidDumpsを利用したら、あなたのキャリアは順調に進むことができるようになります。

Cisco 642-997絶対合格 - 進歩を勇敢に追及する人生こそ素晴らしい人生です。

642-997絶対合格認定試験に合格することは難しいようですね。試験を申し込みたいあなたは、いまどうやって試験に準備すべきなのかで悩んでいますか。そうだったら、下記のものを読んでください。いま642-997絶対合格試験に合格するショートカットを教えてあげますから。あなたを試験に一発合格させる素晴らしい642-997絶対合格試験に関連する参考書が登場しますよ。それはNewValidDumpsの642-997絶対合格問題集です。気楽に試験に合格したければ、はやく試しに来てください。

IT認定試験の出題範囲に対して、NewValidDumpsは豊富な経験を持っています。また、NewValidDumpsは数え切れない受験生を助け、皆さんの信頼と称賛を得ました。

642-997 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 2
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 3
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 4
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 5
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

NewValidDumpsのCiscoのOracle 1z1-071問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。 Juniper JN0-683 - この問題集は絶対あなたがずっと探しているものです。 NewValidDumpsのCiscoのCisco 200-301試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。 CiscoのOracle 1z0-808J認証資格を取得すると、あなたは大きなヘルプを得ることができます。 Microsoft DP-900 - 我々の誠意を信じてください。

Updated: May 28, 2022