642-997受験方法 資格取得

我々はあなたに提供するのは最新で一番全面的なCiscoの642-997受験方法問題集で、最も安全な購入保障で、最もタイムリーなCiscoの642-997受験方法試験のソフトウェアの更新です。無料デモはあなたに安心で購入して、購入した後1年間の無料Ciscoの642-997受験方法試験の更新はあなたに安心で試験を準備することができます、あなたは確実に購入を休ませることができます私たちのソフトウェアを試してみてください。もちろん、我々はあなたに一番安心させるのは我々の開発する多くの受験生に合格させるCiscoの642-997受験方法試験のソフトウェアです。 我々NewValidDumpsはいつでも一番正確なCiscoの642-997受験方法資料を提供するように定期的に更新しています。それに、NewValidDumpsのCiscoの642-997受験方法試験トレーニング資料が一年間の無料更新サービスを提供しますから、あなたはいつも最新の資料を持つことができます。 Ciscoの642-997受験方法試験に失敗しても、我々はあなたの経済損失を減少するために全額で返金します。

CCNP Data Center 642-997 最もよくて最新で資料を提供いたします。

長年の努力を通じて、NewValidDumpsのCiscoの642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)受験方法認定試験の合格率が100パーセントになっていました。 Cisco 642-997 模擬モード「Implementing Cisco Data Center Unified Fabric (DCUFI)」認証試験に合格することが簡単ではなくて、Cisco 642-997 模擬モード証明書は君にとってはIT業界に入るの一つの手づるになるかもしれません。しかし必ずしも大量の時間とエネルギーで復習しなくて、弊社が丹精にできあがった問題集を使って、試験なんて問題ではありません。

あなたはうちのCiscoの642-997受験方法問題集を購入する前に、NewValidDumpsは無料でサンプルを提供することができます。NewValidDumpsを手に入れるのは、Ciscoの642-997受験方法認定試験に合格する鍵を手に入れるのに等しいです。NewValidDumpsの Ciscoの642-997受験方法試験トレーニング資料は高度に認証されたIT領域の専門家の経験と創造を含めているものです。

Cisco 642-997受験方法 - PDF、オンライン問題集または模擬試験ソフトですか。

NewValidDumpsのCiscoの642-997受験方法試験問題資料は質が良くて値段が安い製品です。我々は低い価格と高品質の模擬問題で受験生の皆様に捧げています。我々は心からあなたが首尾よく試験に合格することを願っています。あなたに便利なオンラインサービスを提供して、Cisco 642-997受験方法試験問題についての全ての質問を解決して差し上げます。

我々NewValidDumpsはお客様の立場でお客様に最高のサービスを提供します。全日でのオンライン係員、Ciscoの642-997受験方法試験資料のデモ、豊富なバーション、Ciscoの642-997受験方法試験資料を購入した後の無料更新、試験に失敗した後の全額の返金…これら全部は我々NewValidDumpsが信頼される理由です。

642-997 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 2
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 3
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 4
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 5
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

NewValidDumpsのCiscoのTableau TDA-C01試験トレーニング資料はIT人員の皆さんがそんな目標を達成できるようにヘルプを提供して差し上げます。 NewValidDumps Salesforce Salesforce-MuleSoft-Developer-II問題集を使って試験に合格しない場合に、当社は全額返金できます。 CompTIA PT0-002J - 夢を持ったら実現するために頑張ってください。 弊社のAPEGS NPPE試験問題集によって、あなたの心と精神の満足度を向上させながら、勉強した後APEGS NPPE試験資格認定書を受け取って努力する人生はすばらしいことであると認識られます。 Snowflake ARA-R01 - IT業種で仕事しているあなたは、夢を達成するためにどんな方法を利用するつもりですか。

Updated: May 28, 2022

642-997受験方法 - 642-997日本語版受験参考書 & Implementing Cisco Data Center Unified Fabric (DCUFI)

PDF問題と解答

試験コード:642-997
試験名称:Implementing Cisco Data Center Unified Fabric (DCUFI)
最近更新時間:2024-06-01
問題と解答:全 152
Cisco 642-997 合格内容

  ダウンロード


 

模擬試験

試験コード:642-997
試験名称:Implementing Cisco Data Center Unified Fabric (DCUFI)
最近更新時間:2024-06-01
問題と解答:全 152
Cisco 642-997 受験記対策

  ダウンロード


 

オンライン版

試験コード:642-997
試験名称:Implementing Cisco Data Center Unified Fabric (DCUFI)
最近更新時間:2024-06-01
問題と解答:全 152
Cisco 642-997 合格問題

  ダウンロード


 

642-997 英語版