もしあなたはまだ合格のためにCisco 642-997最新テストに大量の貴重な時間とエネルギーをかかって一生懸命準備し、Cisco 642-997最新テスト「Implementing Cisco Data Center Unified Fabric (DCUFI)」認証試験に合格するの近道が分からなくって、今はNewValidDumpsが有効なCisco 642-997最新テスト認定試験の合格の方法を提供して、君は半分の労力で倍の成果を取るの与えています。 ここには、私たちは君の需要に応じます。NewValidDumpsのCiscoの642-997最新テスト問題集を購入したら、私たちは君のために、一年間無料で更新サービスを提供することができます。 君の初めての合格を目標にします。

CCNP Data Center 642-997 それは確かに君の試験に役に立つとみられます。

CCNP Data Center 642-997最新テスト - Implementing Cisco Data Center Unified Fabric (DCUFI) 世の中に去年の自分より今年の自分が優れていないのは立派な恥です。 それはNewValidDumpsが提供した試験問題資料は絶対あなたが試験に合格することを保証しますから。なんでそうやって言ったのはNewValidDumpsが提供した試験問題資料は最新な資料ですから。

現在IT技術会社に通勤しているあなたは、Ciscoの642-997最新テスト試験認定を取得しましたか？642-997最新テスト試験認定は給料の増加とジョブのプロモーションに役立ちます。短時間で642-997最新テスト試験に一発合格したいなら、我々社のCiscoの642-997最新テスト資料を参考しましょう。また、642-997最新テスト問題集に疑問があると、メールで問い合わせてください。

CiscoのCisco 642-997最新テスト試験に合格するのは最良の方法の一です。

NewValidDumpsの642-997最新テスト問題集は多くの受験生に検証されたものですから、高い成功率を保証できます。もしこの問題集を利用してからやはり試験に不合格になってしまえば、NewValidDumpsは全額で返金することができます。あるいは、無料で試験642-997最新テスト問題集を更新してあげるのを選択することもできます。こんな保障がありますから、心配する必要は全然ないですよ。

Ciscoの642-997最新テスト試験の資料のいくつかのバーションのデモは我々のウェブサイトで無料でダウンロードできます。あなたの愛用する版をやってみよう。

642-997 PDF DEMO:

QUESTION NO: 1
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 2
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

QUESTION NO: 3
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 4
If vPC peer keepalives are used between vPC peers, which VRF is used by default?
A. management
B. default
C. The user must dedicate a VRF for keepalives.
D. system
Answer: A

QUESTION NO: 5
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

Oracle 1z0-808 - なぜ受験生のほとんどはNewValidDumpsを選んだのですか。 その他、Snowflake ARA-C01問題集の更新版を無料に提供します。 NewValidDumpsのCiscoのMicrosoft AZ-104-KR問題集を購入するなら、君がCiscoのMicrosoft AZ-104-KR認定試験に合格する率は１００パーセントです。 その他、Splunk SPLK-2003試験認証証明書も仕事昇進にたくさんのメリットを与えられます。 我々NewValidDumpsは一番効果的な方法を探してあなたにCiscoのMicrosoft DP-600J試験に合格させます。

Updated: May 28, 2022