NewValidDumpsのCiscoの642-997絶対合格トレーニング資料はあなたに期待するものを与えますから。NewValidDumpsを選ぶのは、成功を選ぶということになります。IT業種は急激に発展しているこの時代で、IT専門家を称賛しなければならないです。 Ciscoの642-997絶対合格試験を準備しているあなたに試験に合格させるために、我々NewValidDumpsは模擬試験ソフトを更新し続けています。自分のIT業界での発展を希望したら、Ciscoの642-997絶対合格試験に合格する必要があります。 この認証がどんなに重要するかあなたもよく知っています。

CCNP Data Center 642-997 心はもはや空しくなく、生活を美しくなります。

Ciscoの642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)絶対合格認定試験はIT職員が欠くことができない認証です。 現在IT技術会社に通勤しているあなたは、Ciscoの642-997 模擬対策試験認定を取得しましたか？642-997 模擬対策試験認定は給料の増加とジョブのプロモーションに役立ちます。短時間で642-997 模擬対策試験に一発合格したいなら、我々社のCiscoの642-997 模擬対策資料を参考しましょう。

あなたもきっとそう思うでしょう。ですから、躊躇しないではやく試験を申し込みましょう。Ciscoの642-997絶対合格認定試験は最近最も人気のある試験ですから、受験したいのですか。

Cisco 642-997絶対合格 - NewValidDumpsには専門的なエリート団体があります。

我々の提供するCiscoの642-997絶対合格試験の資料のどのバーションでも各自のメリットを持っています。PDF版はパソコンでもスマホでも利用でき、どこでも読めます。ネットがあれば、オンライン版はどの電子商品でも使用できます。ソフト版は真実のCiscoの642-997絶対合格試験の環境を模倣して、あなたにCiscoの642-997絶対合格試験の本当の感覚を感じさせることができ、いくつかのパソコンでも利用できます。

NewValidDumpsのCiscoの642-997絶対合格試験トレーニング資料を手に入れたら、我々は一年間の無料更新サービスを提供します。それはあなたがいつでも最新の試験資料を持てるということです。

642-997 PDF DEMO:

QUESTION NO: 1
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 2
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 3
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 4
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 5
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

あなたはServiceNow CIS-SPM-JPN問題集を購入するかどうかと確認したい、NewValidDumpsのServiceNow CIS-SPM-JPNデーモ版を使用して購入するかと判断します。 NewValidDumpsのCiscoのScaled Agile SAFe-APM試験トレーニング資料は最高のトレーニング資料です。 受験生のあなたを助けて時間とお金を節約したり、Salesforce Manufacturing-Cloud-Professional試験に速く合格すると保証します。 HP HP2-I65 - NewValidDumpsはあなたが試験に合格するのを助けることができるだけでなく、あなたは最新の知識を学ぶのを助けることもできます。 我々社はあなたがCisco　SAP P-SAPEA-2023試験に一発的に合格するために、最新版の備考資料を提供します。

Updated: May 28, 2022