NewValidDumpsには専門的なエリート団体があります。認証専門家や技術者及び全面的な言語天才がずっと最新のCiscoの642-997教育資料試験を研究していますから、Ciscoの642-997教育資料認定試験に受かりたかったら、NewValidDumpsのサイトをクッリクしてください。あなたに成功に近づいて、夢の楽園に一歩一歩進めさせられます。 うちの学習教材を購入したら、私たちは一年間で無料更新サービスを提供することができます。あなたはCiscoの642-997教育資料問題集を購入する前に、NewValidDumpsは無料でサンプルを提供することができます。 試験の目標が変わる限り、あるいは我々の勉強資料が変わる限り、すぐに更新して差し上げます。

CCNP Data Center 642-997 正しい方法は大切です。

Cisco　642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)教育資料問題集の購買に何か質問があれば、我々の職員は皆様のお問い合わせを待っています。 NewValidDumpsは多くの受験生を助けて彼らにCiscoの642-997 合格率試験に合格させることができるのは我々専門的なチームがCiscoの642-997 合格率試験を研究して解答を詳しく分析しますから。試験が更新されているうちに、我々はCiscoの642-997 合格率試験の資料を更新し続けています。

IT職員にとって、642-997教育資料試験認定書はあなたの実力を証明できる重要なツールです。だから、Cisco　642-997教育資料試験に合格する必要があります。それで、弊社の質高い642-997教育資料試験資料を薦めさせてください。

私たちより、Cisco 642-997教育資料試験を知る人はいません。

NewValidDumpsのCisco　642-997教育資料問題集は専門家たちが数年間で過去のデータから分析して作成されて、試験にカバーする範囲は広くて、受験生の皆様のお金と時間を節約します。我々642-997教育資料問題集の通過率は高いので、90％の合格率を保証します。あなたは弊社の高品質Cisco　642-997教育資料試験資料を利用して、一回に試験に合格します。

NewValidDumpsは多種なIT認証試験を受ける方を正確な資料を提供者でございます。弊社の無料なサンプルを遠慮なくダウンロードしてください。

642-997 PDF DEMO:

QUESTION NO: 1
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 2
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 3
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 4
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

QUESTION NO: 5
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

努力すれば報われますなので、Cisco　Huawei H13-821_V3.0-ENU資格認定を取得して自分の生活状況を改善できます。 SAP C_CPI_2404 - 君が選んだのはNewValidDumps、成功を選択したのに等しいです。 多分、Salesforce Salesforce-Sales-Representativeテスト質問の数が伝統的な問題の数倍である。 Fortinet FCSS_SOC_AN-7.4 - NewValidDumpsは頼りが強い上にサービスもよくて、もし試験に失敗したら全額で返金いたしてまた一年の無料なアップデートいたします。 EMC D-GAI-F-01 - この試験に合格すれば君の専門知識がとても強いを証明し得ます。

Updated: May 28, 2022