あなたより優れる人は存在している理由は彼らはあなたの遊び時間を効率的に使用できることです。どのようにすばらしい人になれますか？ここで、あなたに我々のCisco　642-997復習教材試験問題集をお勧めください。弊社NewValidDumpsの642-997復習教材試験問題集を介して、速く試験に合格して642-997復習教材試験資格認定書を受け入れる一方で、他の人が知らない知識を勉強して優れる人になることに近くなります。 一回だけでCiscoの642-997復習教材試験に合格したい？NewValidDumpsは君の欲求を満たすために存在するのです。NewValidDumpsは君にとってベストな選択になります。 あなたのご遠慮なく購買するために、弊社は提供する無料のCisco　642-997復習教材問題集デーモをダウンロードします。

CCNP Data Center 642-997 暇の時間を利用して勉強します。

我々の目的はあなたにCiscoの642-997 - Implementing Cisco Data Center Unified Fabric (DCUFI)復習教材試験に合格することだけです。 現在の社会で、642-997 クラムメディア試験に参加する人がますます多くなる傾向があります。市場の巨大な練習材料から642-997 クラムメディアの学習教材を手に入れようとする人も増えています。

自分のIT業界での発展を希望したら、Ciscoの642-997復習教材試験に合格する必要があります。Ciscoの642-997復習教材試験はいくつ難しくても文句を言わないで、我々NewValidDumpsの提供する資料を通して、あなたはCiscoの642-997復習教材試験に合格することができます。Ciscoの642-997復習教材試験を準備しているあなたに試験に合格させるために、我々NewValidDumpsは模擬試験ソフトを更新し続けています。

Cisco 642-997復習教材 - 弊社の商品が好きなのは弊社のたのしいです。

NewValidDumpsを選択したら、成功が遠くではありません。NewValidDumpsが提供するCiscoの642-997復習教材認証試験問題集が君の試験に合格させます。テストの時に有効なツルが必要でございます。

NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。

642-997 PDF DEMO:

QUESTION NO: 1
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

QUESTION NO: 2
Which task must be done before a zone set takes effect?
A. Add a member to the zone.
B. Enter the exit config t command.
C. Enter the copy running-config startup-config command.
D. Enter the zoneset activate name <zone-name> vsan <vsan-#> command.
Answer: D

QUESTION NO: 3
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 4
DRAG DROP
Drag the description on the left to the most appropriate Nexus product on the right.
Answer:

QUESTION NO: 5
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

Google Google-Workspace-Administrator - あなたに予想外の良い効果を見せられますから。 あなたはインターネットでCiscoのGoogle Google-Workspace-Administrator認証試験の練習問題と解答の試用版を無料でダウンロードしてください。 それはあなたがいつでも最新のMuleSoft MCIA-Level-1-JPN試験トレーニング資料をもらえるということです。 SAP C_ABAPD_2309 - NewValidDumpsはまた一年間に無料なサービスを更新いたします。 NewValidDumpsのCiscoのIIA IIA-CIA-Part2-JPN試験トレーニング資料はあなたが完全に問題と問題に含まれているコンセプトを理解できることを保証しますから、あなたは気楽に一回で試験に合格することができます。

Updated: May 28, 2022