これはIT認証試験を受ける皆さんのために特別に研究されたもので、１００パーセントの合格率を保証できますから、躊躇わずに購入しましょう。進歩を勇敢に追及する人生こそ素晴らしい人生です。未来のある日、椅子で休むとき、自分の人生を思い出したときに笑顔が出たら成功な人生になります。 気楽に試験に合格したければ、はやく試しに来てください。642-997学習資料認定試験に合格することは難しいようですね。 IT認定試験の出題範囲に対して、NewValidDumpsは豊富な経験を持っています。

CCNP Data Center 642-997 ここには、私たちは君の需要に応じます。

CCNP Data Center 642-997学習資料 - Implementing Cisco Data Center Unified Fabric (DCUFI) この資料を使用すると、あなたの学習効率を向上させ、多くの時間を節約することができます。 NewValidDumpsのCiscoの642-997 日本語Pdf問題試験トレーニング資料は試験問題と解答を含まれて、豊富な経験を持っているIT業種の専門家が長年の研究を通じて作成したものです。その権威性は言うまでもありません。

Ciscoの642-997学習資料認証資格を取得すると、あなたは大きなヘルプを得ることができます。では、どのようにはやく試験に合格するかを知りたいですか。NewValidDumpsの642-997学習資料参考資料はあなたの目標を達成するのに役立ちます。

Cisco 642-997学習資料 - だれでも成功したいのです。

あなたは642-997学習資料試験に不安を持っていますか？642-997学習資料参考資料をご覧下さい。私たちの642-997学習資料参考資料は十年以上にわたり、専門家が何度も練習して、作られました。あなたに高品質で、全面的な642-997学習資料参考資料を提供することは私たちの責任です。私たちより、642-997学習資料試験を知る人はいません。

あなたのすべての需要を満たすためには、一緒に努力します。躊躇われずに我々の模試験を利用してみてください。

642-997 PDF DEMO:

QUESTION NO: 1
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 2
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 3
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 4
Which management feature provides these functions?
* Direct paging of network support engineers
* Email notifications to a network operations center
* Direct Service Request generation with the Cisco TAC
A. scripting along with the scheduler feature
B. RSA
C. Call Home
D. SNMP traps
Answer: C

QUESTION NO: 5
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

Nutanix NCP-MCI-6.5-JPN - 弊社の商品が好きなのは弊社のたのしいです。 弊社NewValidDumpsはCiscoのMicrosoft SC-200問題集を購入し勉強した後、あなたはMicrosoft SC-200試験に合格することでできると信じています。 Salesforce Heroku-Architect - NewValidDumps を選択して１００％の合格率を確保することができて、もし試験に失敗したら、NewValidDumpsが全額で返金いたします。 Cisco　Microsoft DP-300J試験のための一切な需要を満足して努力します。 あなたはインターネットでCiscoのHP HPE6-A78認証試験の練習問題と解答の試用版を無料でダウンロードしてください。

Updated: May 28, 2022