IT認定試験を受ける受験生はほとんど仕事をしている人です。試験に受かるために大量の時間とトレーニング費用を費やした受験生がたくさんいます。ここで我々は良い学習資料のウェブサイトをお勧めします。 最もよくて最新で資料を提供いたします。こうして、君は安心で試験の準備を行ってください。 NewValidDumpsはあなたと苦楽を共にして、一緒に挑戦に直面します。

CCNP Data Center 642-997 では、どうしたらいいでしょうか。

CCNP Data Center 642-997全真模擬試験 - Implementing Cisco Data Center Unified Fabric (DCUFI) その夢は私にとってはるか遠いです。 はCiscoの642-997 日本語練習問題試験に合格するのに、私たちは最も早い時間で合格するのを追求します。

きっと望んでいるでしょう。では、常に自分自身をアップグレードする必要があります。IT業種で仕事しているあなたは、夢を達成するためにどんな方法を利用するつもりですか。

Cisco 642-997全真模擬試験 - 弊社の開発したソフトは非常に全面的です。

NewValidDumpsのCiscoの642-997全真模擬試験試験トレーニング資料は豊富な経験を持っているIT専門家が研究したものです。君がCiscoの642-997全真模擬試験問題集を購入したら、私たちは一年間で無料更新サービスを提供することができます。もしCiscoの642-997全真模擬試験問題集は問題があれば、或いは試験に不合格になる場合は、全額返金することを保証いたします。

今日、我々があなたに提供するCiscoの642-997全真模擬試験ソフトは多くの受験生に検査されました。彼らにCiscoの642-997全真模擬試験試験に合格させました。

642-997 PDF DEMO:

QUESTION NO: 1
What is the Overlay Transport Virtualization site VLAN used for?
A. to allow the join interfaces at different sites to communicate
B. to detect devices at the site that are not capable of OTV
C. to allow multiple site AEDs to communicate with each other
D. to detect other OTV edge devices in the site
Answer: D

QUESTION NO: 2
Which management feature provides these functions?
* Direct paging of network support engineers
* Email notifications to a network operations center
* Direct Service Request generation with the Cisco TAC
A. scripting along with the scheduler feature
B. RSA
C. Call Home
D. SNMP traps
Answer: C

QUESTION NO: 3
Which two functions are enabled when you set up vPC+ at the FabricPath edge? (Choose two.)
A. the ability to attach Cisco Fabric Extenders in FEX active/active mode
B. the ability to stop all Layer 3 egress traffic
C. the ability to attach servers to edge switches with port-channel teaming
D. the ability to attach additional Classic Ethernet switches in vPC+ mode
Answer: A,C

QUESTION NO: 4
Refer to the exhibit.
What is the consequence of configuring peer-gateway on the two vPC peers N7K-1 and N7K-2?
A. Nothing, this is the standard vPC configuration to make the feature work.
B. The downstream device detects only one of the vPC peers as its gateway.
C. The downstream device can use DMAC of N7K-1 on the link to N7K-2, and N7K-2 forwards the packet.
D. This configuration enables the downstream device to use DHCP to obtain its default gateway.
Answer: C
Explanation:
Beginning with Cisco NX-OS 4.2(1), you can configure vPC peer devices to act as the gateway even for packets that are destined to the vPC peer device's MAC address. Use the peer-gateway command to configure this feature.
Some network-attached storage (NAS) devices or load-balancers may have features aimed to optimize the performances of particular applications. Essentially these features avoid performing a routing-table lookup when responding to a request that originated form a host not locally attached to the same subnet. Such devices may reply to traffic using the MAC address of the sender Cisco Nexus
7000 device rather than the common HSRP gateway.
Such behavior is non-complaint with some basic Ethernet RFC standards. Packets reaching a vPC device for the non-local router MAC address are sent across the peer-link and could be dropped by the built in vPC loop avoidance mechanism if the final destination is behind another vPC.
The vPC peer-gateway capability allows a vPC switch to act as the active gateway for packets that are addressed to the router MAC address of the vPC peer. This feature enables local forwarding of such packets without the need to cross the vPC peer-link. In this scenario, the feature optimizes use of the peer-link and avoids potential traffic loss.
Configuring the peer-gateway feature needs to be done on both primary and secondary vPC peers and is non-disruptive to the operations of the device or to the vPC traffic. The vPC peer-gateway feature can be configured globally under the vPC domain submode.
When enabling this feature it is also required to disable IP redirects on all interface VLANs mapped over a vPC VLAN to avoid generation of IP redirect messages for packets switched through the peer gateway router. When the feature is enabled in the vPC domain, the user is notified of such a requirement through an appropriate message.
Packets arriving at the peer-gateway vPC device will have their TTL decremented, so packets carrying
TTL = 1 may be dropped in transit due to TTL expire. This needs to be taken into account when the peer-gateway feature is enabled and particular network protocols sourcing packets with TTL = 1 operate on a vPC VLAN.
Reference: http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/4_2/nx- os/interfaces/configuration/guide/if_nxos/if_vPC.html

QUESTION NO: 5
Which SCSI terminology is used to describe source and destination nodes?
A. hosts and targets
B. initiators and targets
C. HBA and disks
D. initiators and disks
E. HBA and targets
Answer: B
Explanation:
In computer data storage, a SCSI initiator is the endpoint that initiates a SCSI session, that is, sends a
SCSI command. The initiator usually does not provide any Logical Unit
Numbers (LUNs).
On the other hand, a SCSI target is the endpoint that does not initiate sessions, but instead waits for initiators' commands and provides required input/output data transfers. The target usually provides to the initiators one or more LUNs, because otherwise no read or write command would be possible.
Reference: http://en.wikipedia.org/wiki/SCSI_initiator_and_target

弊社のNewValidDumpsはIT認定試験のソフトの一番信頼たるバンドになるという目標を達成するために、弊社はあなたに最新版のCiscoのMicrosoft DP-600J試験問題集を提供いたします。 CiscoのEMC D-SNC-DY-00試験に参加するのを決めるとき、あなたは強い心を持っているのを証明します。 Salesforce Industries-CPQ-Developer - 試験に失敗したら、全額で返金する承諾があります。 お客様か購入する前、我が社NewValidDumpsのEMC D-GAI-F-01問題集の見本を無料にダウンロードできます。 あなたは各バーションのCiscoのCompTIA CV0-003J試験の資料をダウンロードしてみることができ、あなたに一番ふさわしいバーションを見つけることができます。

Updated: May 28, 2022